A Doppler flowmeter for use in theatre.

We have developed a Doppler flowmeter based on a 10 MHz pencil probe and mean frequency estimator which overcomes many of the limitations of existing electromagnetic and ultrasonic flowmeters. The output of the flowmeter, which is proportional to the first moment of the Doppler power spectrum and hence mean blood velocity is linear from 1.3 to over 50 cm s-1 for pulsatile flow. Variation in vessel diameter and angle of insonation, which are the common sources of error in Doppler flowmetry, are minimised by constraining the vessel in a plastic cuff which fixes the probe angle at 50 degrees. A simple gauge is used to compress the vessel flat, before the cuff is applied, to measure the wall thickness to within 0.25 mm. The vessel internal diameter and hence blood flow can then be calculated using an experimentally determined calibration factor to compensate for non-even insonation. A range of sterilizable cuffs from 3-12 mm diameter have been built and the flowmeter is now being used routinely during all arterial reconstructive surgery. The accuracy and reproducibility of the system was tested for range of different sized silastic tubes on a hydraulic model and found to be less than 12% for vessels greater than 2 mm internal diameter. Satisfactory signals were easily obtained from all prosthetic materials with the exception of PTFE. The instantaneous output was compared to an electromagnetic flowmeter using a fast Fourier transform algorithm; the moduli of the harmonics were virtually identical but the Doppler system produced a smaller phase shift with increasing harmonics.(ABSTRACT TRUNCATED AT 250 WORDS)