Department of Orthopaedics, Aarhus University Hospital, Tage-Hansensgade 2, 8000, Aarhus C, Denmark.
Department of Clinical Medicine, Aarhus University, Brendstrupgårdsvej 100, 8200, Aarhus N, Denmark.
Int J Comput Assist Radiol Surg. 2018 Dec;13(12):2021-2028. doi: 10.1007/s11548-018-1802-y. Epub 2018 Jun 6.
Periacetabular osteotomy (PAO) is the treatment of choice for younger patients with developmental hip dysplasia. The procedure aims to normalize the joint configuration, reduce the peak-pressure, and delay the development of osteoarthritis. The procedure is technically demanding and no previous study has validated the use of computer navigation with a minimally invasive transsartorial approach.
Computer-assisted PAO was performed on ten patients. Patients underwent pre- and postoperative computed tomography (CT) scanning with a standardized protocol. Preoperative preparation consisted of outlining the lunate surface and segmenting the pelvis and femur from CT data. The Biomechanical Guidance System was used intra-operatively to automatically calculate diagnostic angles and peak-pressure measurements. Manual diagnostic angle measurements were performed based on pre- and postoperative CT. Differences in angle measurements were investigated with summary statistics, intraclass correlation coefficient, and Bland-Altman plots. The percentage postoperative change in peak-pressure was calculated.
Intra-operative reported angle measurements show a good agreement with manual angle measurements with intraclass correlation coefficient between 0.94 and 0.98. Computer navigation reported angle measurements were significantly higher for the posterior sector angle ([Formula: see text], [Formula: see text]) and the acetabular anteversion angle ([Formula: see text], [Formula: see text]). No significant difference was found for the center-edge ([Formula: see text]), acetabular index ([Formula: see text]), and anterior sector angle ([Formula: see text]). Peak-pressure after PAO decreased by a mean of 13% and was significantly different ([Formula: see text]).
We found that computer navigation can reliably be used with a minimally invasive transsartorial approach PAO. Angle measurements generally agree with manual measurements and peak-pressure was shown to decrease postoperatively. With further development, the system will become a valuable tool in the operating room for both experienced and less experienced surgeons performing PAO. Further studies with a larger cohort and follow-up will allow us to investigate the association with peak-pressure and postoperative outcome and pave the way to clinical introduction.
髋臼周围截骨术(PAO)是治疗发育性髋关节发育不良年轻患者的首选方法。该手术旨在使关节结构正常化,降低峰值压力,延缓骨关节炎的发展。该手术技术要求较高,尚无研究验证计算机导航与微创经关节入路联合使用的效果。
对 10 例患者进行了计算机辅助 PAO。患者均采用标准方案进行术前和术后 CT 扫描。术前准备包括从 CT 数据中勾勒出月状面并分割骨盆和股骨。术中使用生物力学引导系统自动计算诊断角度和峰值压力测量值。根据术前和术后 CT 进行手动诊断角度测量。使用汇总统计、组内相关系数和 Bland-Altman 图比较角度测量值的差异。计算术后峰值压力的变化百分比。
术中报告的角度测量值与手动角度测量值具有良好的一致性,组内相关系数在 0.94 至 0.98 之间。计算机导航报告的角度测量值在后扇区角度([Formula: see text],[Formula: see text])和髋臼前倾角([Formula: see text],[Formula: see text])方面明显更高。中心边缘角([Formula: see text])、髋臼指数([Formula: see text])和前扇区角度([Formula: see text])无显著差异。PAO 后峰值压力平均降低 13%,差异有统计学意义([Formula: see text])。
我们发现计算机导航可与微创经关节入路 PAO 可靠地联合使用。角度测量值通常与手动测量值一致,且术后峰值压力降低。随着进一步的发展,该系统将成为经验丰富和经验较少的外科医生进行 PAO 的手术室中的有价值工具。进一步的研究将纳入更大的队列和随访,以调查与峰值压力和术后结果的关联,并为临床应用铺平道路。