Poon Selina, Spencer Hillard T, Fayssoux Reginald S, Sever Ronen, Cho Robert H
Shriners for Children Medical Center, 909 S. Fair Oaks Ave., Pasadena, CA 91105, USA.
Southern California Permanente Medical Group, 5601 De Soto Ave, Woodland Hills, CA 91367, USA.
Spine Deform. 2018 Nov-Dec;6(6):787-790. doi: 10.1016/j.jspd.2018.03.009.
To evaluate the maximal force generated by magnetically controlled growing rods (MCGRs) at three different lengthened positions.
The introduction of MCGRs has been met with great enthusiasm by surgeons managing early-onset scoliosis. These devices offer the potential to decrease the cost and morbidity associated with repeated surgeries, compared to traditional growing rods. One potential negative consequences of growing rod treatments is the law of diminishing returns, where the spine length gained decrease with each subsequent lengthening. The cause of this phenomenon is unknown and probably multifactorial, yet it may be affected by the strength of the lengthening mechanism in the MCGRs.
Twelve MCGRs (90-mm actuator length) were obtained and tested to evaluate the maximal force generated at different lengths. The maximal lengthening force measured in pounds-of-force generated by each rod was recorded at expansion lengths of 0, 25, and 40 mm. Longitudinal analysis was performed using mixed effects linear regression to account for repeated measures and variability between individual implants.
At 0 mm of actuator lengthening, the mean maximum force was 46.8 lb (standard deviation [SD] 2.06, range 43-50). At 25 mm of expansion, the mean maximum force was 44.9 lb (SD 2.48, range 39.4-49.5). At 40 mm of lengthening, the mean maximum force was 43.2 lb (SD 5.56, range 27.3-49.1). In the mixed effects linear model, there was a statistically significant decrease in the maximal force generated with progressive MCGR lengthening, at an average decrease of 0.089 lb of force (95% CI, 0.030-0.148; p = .003) per millimeter of lengthening.
There is a small but statistically significant decrease in the maximal force generated by MCGR as the rods are lengthened. The decrease in force generated may result in diminished spine length gained with each subsequent MCGR lengthening.
Level IV.
评估磁控生长棒(MCGRs)在三个不同延长位置产生的最大力。
MCGRs的引入受到了治疗早发性脊柱侧弯外科医生的极大欢迎。与传统生长棒相比,这些装置有可能降低与重复手术相关的成本和发病率。生长棒治疗的一个潜在负面后果是收益递减规律,即随着每次后续延长,脊柱获得的长度会减少。这种现象的原因尚不清楚,可能是多因素的,但它可能受MCGRs中延长机制强度的影响。
获取12根MCGRs(致动器长度90毫米)并进行测试,以评估在不同长度下产生的最大力。记录每根棒在0、25和40毫米延长长度时以磅力为单位测量的最大延长力。使用混合效应线性回归进行纵向分析,以考虑重复测量和个体植入物之间的变异性。
在致动器延长0毫米时,平均最大力为46.8磅(标准差[SD]2.06,范围43 - 50)。在延长25毫米时,平均最大力为44.9磅(SD 2.48,范围39.4 - 49.5)。在延长40毫米时,平均最大力为43.2磅(SD 5.56,范围27.3 - 49.1)。在混合效应线性模型中,随着MCGRs逐渐延长,产生的最大力有统计学显著下降,平均每延长一毫米力减少0.089磅(95%CI,0.030 - 0.148;p = 0.003)。
随着生长棒延长,MCGRs产生的最大力有轻微但统计学显著的下降。产生的力的下降可能导致每次后续MCGR延长时脊柱获得的长度减少。
四级。