Augusto Marina Gullo, Borges Alessandra Bühler, Pucci César Rogério, Mailart Mariane Cintra, Torres Carlos Rocha Gomes
Department of Restorative Dentistry, São Paulo State University - UNESP, Institute of Science and Technology, São José dos Campos, São Paulo, Brazil.
Department of Restorative Dentistry, São Paulo State University - UNESP, Institute of Science and Technology, São José dos Campos, São Paulo, Brazil,
Am J Dent. 2018 Dec;31(6):303-308.
To investigate the effects of whitening toothpastes over the wear and surface roughness of ormocer and methacrylate composites.
Cylindrical specimens (n=120) were prepared using methacrylate-based composites (Filtek Z350 XT, TPH3 and GrandioSO) and a pure-ormocer composite (Admira Fusion). Brushing abrasion (100,000 strokes) was performed using whitening toothpastes containing different abrasives: alumina (Colgate Ultrawhite), perlite (CloseUp Whitening) and sodium bicarbonate (Kin Progressive Whitening). Wear and roughness alteration were evaluated. Additional analyses of microhardness, degree of conversion and scanning electron microscopy were also performed.
Data were separately analyzed with Kruskal-Wallis and ANOVA tests. Statistically significant differences were found for the composites and whitening toothpastes (P<0.05). For all toothpastes, GrandioSO showed lower wear than Z350 XT and Admira Fusion, although non-significant differences in relation to TPH3 were observed. For perlite and bicarbonate-based toothpastes, Z350 XT, Admira Fusion and TPH3 did not present significant differences among them for wear. For alumina-based toothpaste, Z350 XT showed higher wear than TPH3, while Admira Fusion showed intermediate values. Higher wear and roughness alteration were observed after using alumina-containing toothpaste. All composites tested showed increased roughness after brushing. Z350 XT presented the lowest roughness alteration, while Admira Fusion the highest.
The alumina-containing whitening toothpaste significantly increased the wear and roughness of composites in relation to the other abrasives tested. However, using the ADA standards, the wear promoted by all whitening toothpastes tested would be considered clinically acceptable for all materials. The type of organic matrix in a composite is not the main factor that determines the wear rate, but also its interaction with the inorganic fillers and the filler content. The composite GrandioSO showed the lowest overall wear values, while Z350 XT resulted in the smoothest surfaces.
