Suppr超能文献

碳纳米管对纳米复合材料热转变、热扩散率和电导率的影响:非晶态和半晶态聚合物基体的比较。

Effects of CNTs on thermal transitions, thermal diffusivity and electrical conductivity in nanocomposites: comparison between an amorphous and a semicrystalline polymer matrix.

机构信息

Department of Physics, National Technical University of Athens, Zografou Campus, 15780, Athens, Greece.

出版信息

Soft Matter. 2019 Feb 20;15(8):1813-1824. doi: 10.1039/c8sm02478b.

Abstract

Two series of polymer nanocomposites (PNCs) based on amorphous styrene-butadiene rubber (SBR) and semicrystalline linear low-density polyethylene (PE) matrices were filled with 2-15 wt% carbon nanotubes (CNT) and were studied by employing calorimetry, dielectric spectroscopy and laser flash analysis. The electrical conductivity, σ, increased with CNT loading and similar values were exhibited for the two matrices, uniquely depending on the concentration of the CNTs, suggesting practically no effects of the crystalline fraction (CF) on σ. For both types of matrix, a fraction of the polymer was found to be immobilized (rigid amorphous fraction, RAF). For the amorphous SBR, the RAF in PNCs originates uniquely from the presence of the filler (RAFfiller up to 0.19 wt). On the other hand, for the semicrystalline PE, the RAF is significantly larger (0.4-0.6 wt) due to the severe contribution of the RAF around the crystals (RAFcrystal). The thermal diffusivity, α, is quite low in both types of PNCs and exhibits higher values in the semicrystalline matrix (PE-based PNCs). Our results suggest that in these PNCs, heat transport mechanisms are activated mainly in the crystalline domains, more so with the additive contribution of the RAFcrystal. In the amorphous SBR-based PNCs, heat transport is facilitated mainly by CNTs, whereas the RAFfiller is found to be a good measure of the thermal resistance behavior of CNT/polymer interphases and consequently, of thermal diffusivity. Direct correlation of the results obtained by the three techniques with each other revealed the systematic dependence of α on the amount of RAF in each matrix; the α(RAF) trends, however, are different for the two matrices. Furthermore, the results suggest that the two RAFs exhibit different structural characteristics, e.g. the RAFcrystal exhibits a more ordered structure than the RAFfiller; this issue is still an open debate in the literature.

摘要

基于无定形苯乙烯-丁二烯橡胶(SBR)和半结晶线性低密度聚乙烯(PE)基体的两组聚合物纳米复合材料(PNC)填充了 2-15wt%的碳纳米管(CNT),并通过量热法、介电谱和激光闪光分析进行了研究。电导率σ随 CNT 负载的增加而增加,两种基体的电导率值相似,仅取决于 CNT 的浓度,这表明结晶分数(CF)对σ几乎没有影响。对于这两种基体,发现一部分聚合物被固定(刚性无定形分数,RAF)。对于无定形 SBR,PNC 中的 RAF 仅源于填充剂的存在(高达 0.19wt%的 RAF filler)。另一方面,对于半结晶 PE,RAF 要大得多(0.4-0.6wt%),这是由于晶体周围 RAF 的严重贡献(RAF crystal)。两种类型的 PNC 的热扩散率α都相当低,并且在半结晶基体(PE 基 PNC)中具有更高的值。我们的结果表明,在这些 PNC 中,热传递机制主要在结晶区中被激活,在 RAF crystal 的添加剂贡献下更是如此。在基于无定形 SBR 的 PNC 中,热传递主要通过 CNT 来促进,而 RAF filler 被发现是 CNT/聚合物界面热阻行为的良好衡量标准,因此也是热扩散率的良好衡量标准。三种技术获得的结果之间的直接相关性表明,α与每个基体中 RAF 的量之间存在系统依赖性;然而,对于两种基体,α(RAF)趋势是不同的。此外,结果表明,两种 RAF 具有不同的结构特征,例如 RAF crystal 比 RAF filler 具有更有序的结构;这个问题在文献中仍然是一个有争议的问题。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验