Suppr超能文献

计算机模拟现代大量输血方案中不同血液制品比例的输血。

Computer simulation of transfusion with different blood product ratios in modern massive transfusion protocols.

机构信息

Department of Anesthesiology and Perioperative Medicine, Queen's University, Kingston K7L 2V7, Ontario, Canada.

Department of Oncology, The Christie NHS Foundation Trust, Wilmslow Rd, M20 4BX Manchester, UK.

出版信息

Med Hypotheses. 2019 Apr;125:10-15. doi: 10.1016/j.mehy.2019.02.004. Epub 2019 Feb 2.

Abstract

Modern massive transfusion protocols call for early plasma and platelets to patients presenting with hemorrhagic shock. The packed red blood cell (PRBC):plasma:platelet ratio generally ranges from 1:1:1 to 3:1:1, but the ideal ratio remains controversial. We aimed to determine the effects of different resuscitation strategies and blood product ratios on hematocrit, platelet and fibrinogen concentrations (FC) during resuscitation. Assuming: pre-insult blood volume 5 L; hematocrit 0.4, FC = 100%, platelet count 400 × 10/L; predetermined constant values for each blood product unit (volume, hematocrit, FC, platelet number); and transfusion rate to maintain euvolemia, we simulated different resuscitation strategies using a computer-based hemorrhage model. When crystalloids are administered to restore an acute 30% blood loss, the initial hematocrit, platelets and FC are adequate, and remain physiologic when further resuscitation is carried out with 1:1:1. Higher transfusion ratios increase the hematocrit at the expense of proportional drops in FC and platelets. When crystalloids and PRBCs (1500 mL) are administered to restore an acute 60% blood loss, the FC drops to 39%. Further resuscitation with 1:1:1 (but not with 2:1:1 or 3:1:1) increases the FC while maintaining the hematocrit and platelets within physiologic range. When blood products (1-3:1:1) are administered to restore an acute 60% blood loss, the initial hematocrit, platelets and FC are at adequate levels, but remain within physiologic range only when 1:1:1 (but not 2:1:1 or 3:1:1) is implemented for further resuscitation. Notably, platelet concentration consistently drops in all simulated scenarios reaching dangerously low levels particularly with high blood loss/transfusion rates and with higher transfusion ratios. The FC does not always drop by the same proportion with higher ratios probably because it is based on plasma concentration and is thus "cushioned" by the reduction in plasma volume as the hematocrit rises with higher transfusion ratios. In summary, computer simulation suggests that in non-severe shock hemorrhage, the differences between 1-3:1:1 transfusion ratios during initial resuscitation may be small. In severe shock, however, 1:1:1 results in the most physiologic hematocrit, FC and platelet concentration and is, therefore, desirable.

摘要

现代大量输血方案呼吁对出血性休克患者早期输注血浆和血小板。浓缩红细胞(PRBC):血浆:血小板的比例通常为 1:1:1 至 3:1:1,但理想的比例仍存在争议。我们旨在确定不同复苏策略和血液制品比例对复苏期间血细胞比容、血小板和纤维蛋白原浓度(FC)的影响。假设:创伤前血容量 5L;血细胞比容 0.4,FC=100%,血小板计数 400×10/L;每个血液制品单位的预定常数值(体积、血细胞比容、FC、血小板数);以及维持血容量正常的输血率,我们使用基于计算机的出血模型模拟了不同的复苏策略。当晶体液用于恢复急性 30%的失血时,初始血细胞比容、血小板和 FC 是足够的,当进一步用 1:1:1 进行复苏时,FC 仍保持生理水平。更高的输血比例会增加血细胞比容,而 FC 和血小板的比例会相应下降。当晶体液和 PRBC(1500mL)用于恢复急性 60%的失血时,FC 下降至 39%。进一步用 1:1:1(但不是 2:1:1 或 3:1:1)复苏可增加 FC,同时将血细胞比容和血小板维持在生理范围内。当用血液制品(1-3:1:1)恢复急性 60%的失血时,初始血细胞比容、血小板和 FC 处于足够水平,但只有在实施 1:1:1(但不是 2:1:1 或 3:1:1)进一步复苏时,FC 才保持在生理范围内。值得注意的是,在所有模拟情况下,血小板浓度持续下降,尤其是在高失血量/输血率和更高输血比例下,血小板浓度会降至危险水平。由于 FC 基于血浆浓度,因此随着更高的输血比例,血细胞比容升高会导致血浆体积减少,从而“缓冲”其下降,因此其下降比例并不总是与更高的比例相同。总之,计算机模拟表明,在非严重休克性出血中,初始复苏期间 1-3:1:1 输血比例的差异可能较小。然而,在严重休克中,1:1:1 可获得最生理的血细胞比容、FC 和血小板浓度,因此是理想的选择。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验