House C, Wettenhall R E, Kemp B E
J Biol Chem. 1987 Jan 15;262(2):772-7.
The substrate specificity of protein kinase C has been examined using a series of synthetic peptide analogs of glycogen synthase, ribosomal protein S6, and the epidermal growth factor receptor. The glycogen synthase analog peptide Pro1-Leu-Ser-Arg-Thr-Leu-Ser-Val-Ala-Ala10 was phosphorylated at Ser7 with a Km of 40.3 microM. Peptide phosphorylation was strongly dependent on Arg4. When lysine was substituted for Arg4 the Km was increased approximately 20-fold. Addition of basic residues on either the NH2-terminal or COOH-terminal side of the phosphorylation site of the glycogen synthase peptide improved the kinetics of peptide phosphorylation. The analog Pro-Leu-Ser-Arg-Thr-Leu-Ser-Val-Ala-Ala-Lys-Lys was phosphorylated with a Km of 4.1 microM. Substitution of Ser7 with threonine increased the apparent Km to 151 microM. The truncated peptide Pro1-Leu-Ser-Arg-Thr-Leu-Ser-Val8 was phosphorylated with similar kinetic constants to the parent peptide, however, deletion of Val8 increased the apparent Km to 761 microM. The ribosomal peptide S6-(229-239) was phosphorylated with a Km of approximately 0.5 microM predominantly on Ser236 and is one of the most potent synthetic peptide substrates reported for a protein kinase. The apparent Km for S6 peptide phosphorylation was increased by either deletion of the NH2-terminal 3 residues Ala229-Arg-231 or by substitution of Arg238 on the COOH-terminal side of the phosphorylation site with alanine. This analog peptide, [Ala238]S6-(229-239) was phosphorylated with an approximate 6-fold reduction in Vmax and a switch in the preferred site of phosphorylation from Ser236 to Ser235. These results support the concept that basic residues on both sides of the phosphorylation site can have an important influence on the kinetics of phosphorylation and site specificity of protein kinase C.
利用糖原合酶、核糖体蛋白S6和表皮生长因子受体的一系列合成肽类似物,研究了蛋白激酶C的底物特异性。糖原合酶类似物肽Pro1-Leu-Ser-Arg-Thr-Leu-Ser-Val-Ala-Ala10在Ser7处被磷酸化,Km为40.3微摩尔。肽的磷酸化强烈依赖于Arg4。当用赖氨酸取代Arg4时,Km增加约20倍。在糖原合酶肽磷酸化位点的NH2末端或COOH末端添加碱性残基可改善肽磷酸化的动力学。类似物Pro-Leu-Ser-Arg-Thr-Leu-Ser-Val-Ala-Ala-Lys-Lys以4.1微摩尔的Km被磷酸化。用苏氨酸取代Ser7使表观Km增加到151微摩尔。截短的肽Pro1-Leu-Ser-Arg-Thr-Leu-Ser-Val8以与亲本肽相似的动力学常数被磷酸化,然而,缺失Val8使表观Km增加到761微摩尔。核糖体肽S6-(229-239)以约0.5微摩尔的Km主要在Ser236处被磷酸化,是报道的蛋白激酶最有效的合成肽底物之一。S6肽磷酸化的表观Km通过缺失NH2末端的3个残基Ala229-Arg-231或通过用丙氨酸取代磷酸化位点COOH末端的Arg238而增加。这种类似物肽,[Ala238]S6-(229-239)被磷酸化时,Vmax降低约6倍,磷酸化的优选位点从Ser236切换到Ser235。这些结果支持这样的概念,即磷酸化位点两侧的碱性残基可对蛋白激酶C的磷酸化动力学和位点特异性产生重要影响。