Shanghai Key Laboratory of Orthopaedic Implants, Department of Orthopaedic Surgery, Shanghai Ninth People's Hospital, Shanghai Jiao Tong University School of Medicine, School of Biomedical Engineering, Shanghai Jiao Tong University, Shanghai, China.
Leiden University Medical Center, Leiden, the Netherlands.
Am J Sports Med. 2019 Jun;47(7):1645-1653. doi: 10.1177/0363546519840278. Epub 2019 May 9.
Medial patellofemoral ligament (MPFL) reconstruction is associated with a high rate of complications, including recurrent instability and persistent knee pain. Technical errors are among the primary causes of these complications. Understanding the effect of adjusting patellofemoral attachments on length change patterns may help surgeons to optimize graft placement during MPFL reconstruction and to reduce graft failure rates.
To determine the in vivo length changes of the MPFL during dynamic, weightbearing motion and to map the isometry of the 3-dimensional wrapping paths from various attachments on the medial femoral epicondyle to the patella.
Descriptive laboratory study.
Fifteen healthy participants were studied with a combined computed tomography and biplane fluoroscopic imaging technique during a lunge motion (full extension to ~110° of flexion). On the medial femoral epicondyle, 185 attachments were projected, including the anatomic MPFL footprint, which was divided into 5 attachments (central, proximal, distal, posterior, and anterior). The patellar MPFL area was divided into 3 possible attachments (proximal, central, and distal). The length changes of the shortest 3-dimensional wrapping paths of the various patellofemoral combinations were subsequently measured and mapped.
For the 3 patellar attachments, the most isometric attachment, with an approximate 4% length change, was located posterior and proximal to the anatomic femoral MPFL attachment, close to the adductor tubercle. Attachments proximal and anterior to the isometric area resulted in increasing lengths with increasing knee flexion, whereas distal and posterior attachments caused decreasing lengths with increasing knee flexion. The anatomic MPFL was tightest in extension, decreased in length until approximately 30° of flexion, and then stayed near isometric for the remainder of the motion. Changing both the femoral and patellar attachments significantly affected the length changes of the anatomic MPFL ( P < .001 for both).
The most isometric location for MPFL reconstruction was posterior and proximal to the anatomic femoral MPFL attachment. The anatomic MPFL is a dynamic, anisometric structure that was tight in extension and early flexion and near isometric beyond 30° of flexion.
Proximal and anterior MPFL tunnel positioning should be avoided, and the importance of anatomic MPFL reconstruction is underscored with the results found in this study.
内侧髌股韧带(MPFL)重建与较高的并发症发生率相关,包括复发性不稳定和持续的膝关节疼痛。技术错误是这些并发症的主要原因之一。了解调整髌股附著处对长度变化模式的影响,可能有助于外科医生在 MPFL 重建过程中优化移植物的放置,并降低移植物失败的发生率。
确定 MPFL 在动态、负重运动过程中的实际长度变化,并绘制从内侧股骨髁上的各种附著处到髌骨的 3 维包裹路径的等距图。
描述性实验室研究。
15 名健康参与者在进行弓步运动(从完全伸展到约 110°屈曲)时,采用计算机断层扫描和双平面荧光透视成像技术进行研究。在股骨内上髁上投射了 185 个附著处,包括解剖 MPFL 足迹,该足迹分为 5 个附著处(中央、近端、远端、后和前)。髌骨 MPFL 区分为 3 个可能的附著处(近端、中央和远端)。随后测量并绘制了各种髌股组合的最短 3 维包裹路径的长度变化。
对于 3 个髌骨附著处,最等距的附著处,长度变化约为 4%,位于解剖股骨 MPFL 附著处的后和近端,靠近收肌结节。等距区域近端和前方的附著处导致随膝关节屈曲增加而增加长度,而远端和后方的附著处导致随膝关节屈曲增加而减小长度。解剖 MPFL 在伸展时最紧,在大约 30°屈曲时长度减小,然后在运动的其余部分保持接近等距。同时改变股骨和髌骨的附著处显著影响解剖 MPFL 的长度变化(两者均<0.001)。
MPFL 重建的最等距位置是在解剖股骨 MPFL 附著处的后和近端。解剖 MPFL 是一个动态的、各向异性的结构,在伸展和早期屈曲时紧张,在超过 30°屈曲时接近等距。
应避免股骨近端和前方的 MPFL 隧道定位,并强调本研究结果对解剖 MPFL 重建的重要性。