Suppr超能文献

膜蒸馏作为厌氧流化床膜生物反应器用于有机和氮去除的后处理。

Membrane distillation as post-treatment for anaerobic fluidized bed membrane bioreactor for organic and nitrogen removal.

机构信息

Department of Environmental Engineering, Inha University, Michuholgu, Inharo-100, Incheon, Republic of Korea.

Department of Environmental Engineering, Inha University, Michuholgu, Inharo-100, Incheon, Republic of Korea; Department of Chemical Engineering, COMSATS University Islamabad (CUI), Lahore Campus, Pakistan.

出版信息

Chemosphere. 2019 Nov;234:756-762. doi: 10.1016/j.chemosphere.2019.06.043. Epub 2019 Jun 6.

Abstract

To observe feasibility of membrane distillation (MD) as post-treatment for anaerobic fluidized bed membrane bioreactor (AFMBR), removals of organic and total nitrogen were investigated by using the commercial polyvinylidene difluoride (PVDF) membrane for direct contact membrane distillation (DCMD) at various operational conditions. Test solutions for MD experiments were permeate produced by staged AFMBR (SAF-MBR), permeate from single AFMBR and synthetic wastewater fed to both reactors. Increasing in feed temperature improved permeate flux through PVDF membrane, but it decreased total nitrogen (TN) removal efficiency. Effect of chemical oxygen demand (COD) concentrations in feed solutions for DCMD on TN removal efficiency was almost negligible. However, the COD removal efficiency was lower at lower feed concentration in DCMD operation. At constant feed temperature, TN removal efficiency was improved by increasing a recirculation flow rate on PVDF membrane across DCMD system. Both organic and inorganic fouling were observed on PVDF membrane surface and pore matrix after conducting DCMD operation. The organic fouling on PVDF membrane consisted mainly of protein and fatty acids, supporting that the permeate produced by AFMBR should have potentials to foul the membrane applied in DCMD system as post-treatment.

摘要

为了观察膜蒸馏(MD)作为厌氧流化床膜生物反应器(AFMBR)后处理的可行性,采用商业聚偏二氟乙烯(PVDF)膜在不同操作条件下进行直接接触膜蒸馏(DCMD),考察了对有机和总氮的去除效果。MD 实验的测试溶液为分阶段 AFMBR(SAF-MBR)的渗透物、单 AFMBR 的渗透物和供给两个反应器的合成废水。进料温度的升高提高了 PVDF 膜的渗透通量,但降低了总氮(TN)去除效率。DCMD 中进料溶液中化学需氧量(COD)浓度对 TN 去除效率的影响几乎可以忽略不计。然而,在 DCMD 操作中,进料浓度较低时 COD 去除效率较低。在恒定的进料温度下,通过增加 PVDF 膜跨 DCMD 系统的循环流量,提高了 TN 的去除效率。在进行 DCMD 操作后,PVDF 膜表面和孔基质上都观察到了有机和无机结垢。PVDF 膜上的有机结垢主要由蛋白质和脂肪酸组成,这表明 AFMBR 产生的渗透物有可能在作为后处理的 DCMD 系统中污染膜。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验