Orthopaedic Robotics Laboratory, Departments of Orthopaedic Surgery and Bioengineering, University of Pittsburgh, Pittsburgh, Pennsylvania, USA.
Orthopaedics and Traumatology Sports Center, Department of Orthopaedics and Traumatology, Paulista School of Medicine, Federal University of São Paulo, São Paulo, Brazil.
Am J Sports Med. 2019 Aug;47(10):2427-2436. doi: 10.1177/0363546519858085. Epub 2019 Jun 28.
The ability of lateral meniscal allograft transplantation (MAT) to improve knee stability and the meniscal load-bearing function in patients after meniscectomy is critical for surgical success.
To compare the effects of 2 lateral MAT fixation techniques-bone block and suture only-on knee kinematics and forces.
Controlled laboratory study.
With a robotic testing system, loads were applied during flexion on 10 fresh-frozen cadaveric knees: 134-N anterior tibial load + 200-N axial compression, 5-N·m internal tibial + 5-N·m valgus torques, and 5-N·m external tibial + 5-N·m valgus torques. Kinematic data were recorded for 4 knee states: intact, total lateral meniscectomy, lateral MAT bone block, and lateral MAT suture-only fixation. In situ force in the anterior cruciate ligament and resultant forces in the lateral meniscus and in the meniscal allograft were quantified via the principle of superposition. A repeated measures analysis of variance was used to analyze variations in kinematics and forces at 0°, 30°, 60°, and 90° of knee flexion. Significance was set at < .05.
When anterior loads were applied, a decrease in medial translation of the tibia that was increased after total lateral meniscectomy was observed at 30°, 60°, and 90° of knee flexion for both the lateral MAT bone block (54.2%, 48.0%, and 50.0%) and the MAT suture-only (50.0%, 40.0%, and 34.6%) fixation techniques ( < .05). Yet, most of the increases in knee kinematics after lateral meniscectomy were not significantly reduced by either lateral MAT technique ( > .05 for each MAT technique vs the total lateral meniscectomy state). Resultant forces in the meniscal allograft were 50% to 60% of the resultant forces in the intact lateral meniscus in response to all loading conditions at all flexion angles ( < .05). Overall, no significant differences between lateral MAT techniques were observed regarding kinematics and forces ( > .05).
Lateral MAT partially restored medial translation of the tibia, and the resultant forces in the meniscal allograft were only 50% to 60% of the intact lateral meniscus forces in the cadaver model. In the majority of testing conditions, no significant changes of the in situ force in the anterior cruciate ligament were observed. Surgeons should consider the potential benefits of lateral MAT when deciding the appropriate treatment for symptomatic patients after lateral meniscectomies. Both lateral MAT techniques functioned similarly.
The load-bearing function of the meniscal allograft observed in this study may be beneficial in ameliorating the short- and long-term disability associated with lateral meniscal deficiency.
外侧半月板同种异体移植(MAT)改善半月板切除术后患者膝关节稳定性和半月板承重功能的能力对手术成功至关重要。
比较两种外侧 MAT 固定技术(骨块和仅缝线)对膝关节运动学和力学的影响。
对照实验室研究。
在机器人测试系统上,对 10 个新鲜冷冻尸体膝关节施加屈曲时的载荷:胫骨前 134-N 加载+200-N 轴向压缩、胫骨内 5-N·m+5-N·m 外翻扭矩、胫骨外 5-N·m+5-N·m 外翻扭矩。记录 4 个膝关节状态的运动学数据:完整、全外侧半月板切除、外侧 MAT 骨块和外侧 MAT 仅缝线固定。通过叠加原理定量测量前交叉韧带的原位力和外侧半月板及半月板移植物的合力。采用重复测量方差分析分析膝关节 0°、30°、60°和 90°屈曲时运动学和力学的变化。显著性水平设为 <.05。
当施加前负荷时,与全外侧半月板切除后相比,胫骨内侧平移的减小在 30°、60°和 90°的膝关节屈曲时观察到,外侧 MAT 骨块(54.2%、48.0%和 50.0%)和 MAT 仅缝线(50.0%、40.0%和 34.6%)固定技术( <.05)。然而,外侧半月板切除术后膝关节运动学的大部分增加并没有被任何一种外侧 MAT 技术显著减少(每种 MAT 技术与全外侧半月板切除状态相比, >.05)。在所有加载条件下,在所有屈曲角度下,半月板移植物的合力均为完整外侧半月板的 50%至 60%( <.05)。总体而言,两种外侧 MAT 技术在运动学和力学方面无显著差异( >.05)。
外侧 MAT 部分恢复了胫骨的内侧平移,半月板移植物的合力仅为尸体模型中完整外侧半月板的 50%至 60%。在大多数测试条件下,前交叉韧带的原位力没有明显变化。当决定对外侧半月板切除术后有症状的患者进行适当的治疗时,外科医生应考虑外侧 MAT 的潜在益处。两种外侧 MAT 技术的功能相似。
本研究观察到的半月板移植物的承重功能可能有助于改善与外侧半月板缺失相关的短期和长期残疾。