Key Laboratory for Biomechanics and Mechanobiology of Ministry of Education, School of Biological Science and Medical Engineering, Beihang University, Beijing, China.
School of Mechanical Engineering, Hebei University of Technology, Tianjin, China.
BMC Musculoskelet Disord. 2019 Aug 14;20(1):370. doi: 10.1186/s12891-019-2728-4.
Scoliosis is a serious disease that can affect all segments of society. Few studies have investigated the response to vibration of differing sinusoidal axial cyclic loading frequencies for different forms of scoliosis in the lumbar spine.
In this study, four finite element models, comprising a healthy spine, Lenke-A, Lenke-B and Lenke-C scoliosis of the lumbar S1-L1 region were developed. Modal analysis extracted resonant frequencies of the FE models with an upper body mass of 40 kg and 400 N preload. A transient dynamic analysis was performed to obtain the response to vibration of models under a sinusoidal axial loading of ± 40N at frequencies of 3, 5, 7, 9, 11 and 13 Hz using an upper body mass of 40 kg and 400 N preload.
The first-order resonant frequencies of healthy, Lenke-A, Lenke-B and Lenke-C spines were 9.2, 3.9, 4.6 and 5.7 Hz, respectively. A Lenke-A lumbar spine was more likely to deform at a lower vibration frequency and Lenke-C deformed more easily at a higher vibration frequency. Furthermore, the vibration amplitude in the Y-direction (left-right) was greatest and least in the Z-direction (top-bottom). The frequency of cyclic loading closest to the resonant frequency resulted in a maximum value of peak-to-peak vibrational displacement. Furthermore, the vibrational amplitudes in patients with scoliosis were larger than they were in healthy subjects. In addition, axial displacement of the vertebrae in the healthy spine changed steadily whereas fluctuations in the scoliotic vertebrae in scoliosis patients were greater than that of other vertebrae.
Different forms of scoliosis may have different vibrational characteristics, the scoliotic vertebrae being the weak link in scoliosis under loading condition of whole body vibration. Scoliosis was more sensitive to this form of vibration. Where the frequency of axial cyclic vibrational loading of the lumbar spine was closer to its resonant frequency, the vibrational amplitude was larger. These results suggest that vibration will exacerbate the degree of scoliosis and so such patients should reduce their exposure to vibration. Clinical treatment should pay attention to the scoliotic vertebrae and reduce their vibration. These findings may assist in the clinical prevention and treatment of scoliosis.
脊柱侧凸是一种严重的疾病,可影响社会的各个阶层。很少有研究调查过不同形式的腰椎脊柱侧凸对不同正弦轴向循环加载频率的振动响应。
本研究建立了四个有限元模型,包括健康脊柱、Lenke-A、Lenke-B 和 Lenke-C 型腰椎 S1-L1 脊柱侧凸。模态分析提取了上半身质量为 40kg 和预载 400N 时 FE 模型的固有频率。在正弦轴向加载±40N 的情况下,采用上半身质量为 40kg 和预载 400N,对模型进行瞬态动力学分析,以获得在 3、5、7、9、11 和 13Hz 频率下的振动响应。
健康、Lenke-A、Lenke-B 和 Lenke-C 脊柱的一阶固有频率分别为 9.2、3.9、4.6 和 5.7Hz。Lenke-A 型腰椎在较低的振动频率下更容易变形,而 Lenke-C 型在较高的振动频率下更容易变形。此外,Y 方向(左右)的振动幅度最大,Z 方向(上下)的振动幅度最小。与固有频率最接近的循环加载频率会导致峰峰值振动位移达到最大值。此外,脊柱侧凸患者的振动幅度大于健康受试者。此外,健康脊柱的椎体轴向位移稳定变化,而脊柱侧凸患者的畸形椎体波动大于其他椎体。
不同形式的脊柱侧凸可能具有不同的振动特征,在全身振动加载条件下,脊柱侧凸的畸形椎体是脊柱侧凸的薄弱环节。脊柱侧凸对这种形式的振动更为敏感。当腰椎轴向循环振动加载频率更接近其固有频率时,振动幅度越大。这些结果表明,振动会加重脊柱侧凸的程度,因此此类患者应减少振动暴露。临床治疗应注意脊柱侧凸椎体,减少其振动。这些发现可能有助于临床预防和治疗脊柱侧凸。