Narayanam Pavan K, Botcha V Divakar, Ghosh Monalisa, Major S S
Materials Chemistry & Metal Fuel Cycle Group, Indira Gandhi Centre for Atomic Research, Kalpakkam-603102, India.
Nanotechnology. 2019 Nov 29;30(48):485601. doi: 10.1088/1361-6528/ab3ced.
Reduced graphene oxide-zinc oxide (rGO-ZnO) nanocomposites were grown on solid substrates by rapid thermal treatment of Langmuir-Blodgett transferred GO-Zn composite sheets in oxygen ambient. The changes induced by uptake of Zn ions and subsequent thermal treatment on surface morphology, micro-structure, composition and optical properties of composite sheets were investigated by atomic force microscopy, high resolution transmission electron microscopy (HR-TEM), X-ray photoelectron spectra (XPS), Fourier transform infrared (FT-IR) and Raman measurements. The morphological features of composites are practically independent of subphase Zn concentration and are largely determined by the temperature of rapid thermal treatment. FT-IR results indicate the presence of zinc carboxylate in composites and HR-TEM results confirm the formation of ZnO nanoparticles upon subsequent oxidation. XPS and Raman measurements show that rapid thermal treatment in oxygen ambient results in decrease of carbon-oxygen functional groups and increase in graphitic carbon content leading to the reduction of GO in the composites. The average optical transmittance of rGO-ZnO composites in the visible region is found to be ∼87%. Photocatalytic studies carried out on methylene blue (MB) overlayer coated rGO-ZnO composites show reduction in concentration of MB with increasing duration of UV irradiation. The transparent two-dimensional rGO-ZnO composite solid state structures thus facilitate efficient adsorption and degradation of MB molecules, without any composite aggregation.
通过在氧气环境中对朗缪尔-布洛杰特转移的氧化石墨烯-锌(GO-Zn)复合片材进行快速热处理,在固体基板上生长了还原氧化石墨烯-氧化锌(rGO-ZnO)纳米复合材料。通过原子力显微镜、高分辨率透射电子显微镜(HR-TEM)、X射线光电子能谱(XPS)、傅里叶变换红外光谱(FT-IR)和拉曼测量,研究了锌离子的吸收以及随后的热处理对复合片材的表面形态、微观结构、组成和光学性能所引起的变化。复合材料的形态特征实际上与亚相锌浓度无关,并且在很大程度上由快速热处理的温度决定。FT-IR结果表明复合材料中存在羧酸锌,HR-TEM结果证实了随后氧化时氧化锌纳米颗粒的形成。XPS和拉曼测量表明,在氧气环境中进行快速热处理会导致碳氧官能团减少,石墨碳含量增加,从而使复合材料中的氧化石墨烯还原。发现rGO-ZnO复合材料在可见光区域的平均透光率约为87%。对涂覆有亚甲基蓝(MB)覆盖层的rGO-ZnO复合材料进行的光催化研究表明,随着紫外线照射时间的增加,MB浓度降低。因此,透明的二维rGO-ZnO复合固态结构有助于MB分子的有效吸附和降解,且不会发生任何复合材料聚集。