Hamanaka Kazutoshi, Takayama Hiroki, Koyama Tsutomu, Matsuoka Shunichiro, Takeda Tetsu, Agatsuma Hiroyuki, Yamada Kyoko, Hyogotani Akira, Kawakami Satoshi, Ito Ken-Ichi
Department of Thoracic Surgery, Shinshu University School of Medicine, Nagano, Japan.
Department of Radiology, Shinshu University School of Medicine, Nagano, Japan.
J Thorac Dis. 2019 Jul;11(7):2924-2931. doi: 10.21037/jtd.2019.07.34.
In the current lung cancer tumor-node-metastasis classification, solid tumor size is used for tumor diameter measurement as the dense component. However, measuring solid tumor size is sometimes difficult and inter-observer variability may increase, particularly in part-solid nodules with ground-glass opacity (GGO). This study aimed to investigate inter-observer size measurement variability in lung adenocarcinoma.
Of 47 patients with part-solid lung adenocarcinoma who had undergone surgery at our department from January to December 2016, five surgeons and one radiologist undertook unidimensional solid and total size tumor measurements using pre-operative axial computed tomography images, and we assessed inter-observer size measurement variability. Variability was then subclassified into five groups, according to computer tomography-identified tumor morphological characteristics, namely: (I) minimally invasive; (II) peribronchovascular; (III) spiculation/atelectasis; (IV) adjacent to cystic lesion, and; (V) diffuse consolidation and GGO.
The mean inter-observer variability was 9.7 mm (solid size) and 7.7 mm (total size). Analysis of the maximum and minimum measurement size values for each patient undertaken showed that the most experienced surgeon and the radiologist measured the minimum size more frequently. To correct for differences in mean tumor diameter in each group, a comparison was made using a coefficient of variation (CV) calculated as the ratio of the standard deviation to the mean. Group I characteristics showed the largest coefficient value for variation in solid size measurement.
Inter-observer measurement variability for solid size was larger than for total size in lung adenocarcinoma. Large variability in group I indicated the difficulty of size measurement for low-grade malignant potential nodules such as adenocarcinoma in situ, minimally invasive adenocarcinoma, and early-stage invasive adenocarcinoma. The possibility of unavoidable size measurement variability should be recognized when deciding on surgical procedures for these diseases.
在当前的肺癌肿瘤-淋巴结-转移分类中,实性肿瘤大小作为致密成分用于肿瘤直径测量。然而,测量实性肿瘤大小有时很困难,且观察者间的变异性可能会增加,尤其是在伴有磨玻璃影(GGO)的部分实性结节中。本研究旨在调查肺腺癌观察者间大小测量的变异性。
对2016年1月至12月在我科接受手术的47例部分实性肺腺癌患者,5名外科医生和1名放射科医生使用术前轴向计算机断层扫描图像进行一维实性和总大小肿瘤测量,并评估观察者间大小测量的变异性。然后根据计算机断层扫描确定的肿瘤形态特征将变异性细分为五组,即:(I)微浸润;(II)支气管血管周围型;(III)毛刺/肺不张型;(IV)邻近囊性病变型,以及;(V)弥漫性实变和GGO型。
观察者间的平均变异性为9.7mm(实性大小)和7.7mm(总大小)。对每位患者的最大和最小测量大小值进行分析表明,经验最丰富的外科医生和放射科医生更频繁地测量到最小尺寸。为校正每组平均肿瘤直径的差异,使用变异系数(CV)进行比较,变异系数计算为标准差与平均值之比。I组特征在实性大小测量中显示出最大的变异系数值。
肺腺癌中,观察者间实性大小测量的变异性大于总大小测量的变异性。I组的大变异性表明,对于原位腺癌、微浸润腺癌和早期浸润腺癌等低恶性潜能结节,大小测量存在困难。在决定这些疾病的手术方案时,应认识到不可避免的大小测量变异性的可能性。