Department of Civil Engineering and Architecture, University of Catania, Via Santa Sofia 64, 95123, Catania, Italy.
Faculty of Engineering and Architecture, Kore University of Enna, Cittadella Universitaria, 94100, Enna, Italy.
J Environ Manage. 2020 Jan 15;254:109796. doi: 10.1016/j.jenvman.2019.109796. Epub 2019 Nov 12.
Plastic films can be considered as a high-value auxiliary material in agriculture with multiple important uses to fulfil, including covering films in greenhouse cultivation system. Such an application enables several benefits and, therefore, it is going through an important upsurge, especially in regions where protected crop cultivation is highly widespread. However, the increased demand for these covering films arouses concerns for their post-use treatment with regard to both the consumption of Non-Renewable Primary Energy (NRPE) resources and the emission of Greenhouse Gases (GHGs). Therefore, environmental analysis is needed to find and follow cleaner paths for the management and treatment of this kind of Agricultural Plastic Waste (APW), especially in the light of the gap currently existing in the specialised literature. In this context, this paper reports upon findings from a combined Life Cycle Assessment (LCA) of single environmental issues (i.e., energy and water consumption, and GHG emissions) applied to a Sicilian firm, representative of APW collection and recycling to obtain Low-Density Polyethylene (LDPE) granules. The results showed that electricity consumption for the whole recycling process is the most NRPE resource demanding and the most GHG emitting input item. Moreover, the washing phase of disused covering films is the highest water demanding within the recycling process. Potential improvements could be achieved by shifting from fossil energy source to renewable one. The installation of a wind power plant would lead to around 56% and 85% reduction in NRPE resource exploitation and GHG emission, respectively. Finally, despite the huge consumption of water and NRPE resources and the resulting GHG emissions, the production of recycled-LDPE granules is far more sustainable than the virgin counterpart.
塑料薄膜可以被认为是农业中的一种高价值辅助材料,具有多种重要用途,包括在温室种植系统中使用覆盖膜。这种应用带来了多种好处,因此,它正在经历一个重要的热潮,特别是在保护作物种植高度普及的地区。然而,对这些覆盖膜的需求增加引起了人们对其使用后的处理的关注,特别是考虑到不可再生初级能源 (NRPE) 资源的消耗和温室气体 (GHG) 的排放。因此,需要进行环境分析,以找到并遵循更清洁的管理和处理这种农业塑料废物 (APW) 的路径,特别是鉴于专业文献中目前存在的差距。在这种情况下,本文报告了对西西里岛一家代表 APW 收集和回收以获得低密度聚乙烯 (LDPE) 颗粒的公司进行的单一环境问题(即能源和水消耗以及 GHG 排放)的生命周期评估 (LCA) 的综合研究结果。结果表明,整个回收过程中电力消耗是对 NRPE 资源需求最大和 GHG 排放最多的投入项目。此外,废旧覆盖膜的清洗阶段是回收过程中用水最多的阶段。通过从化石能源转向可再生能源,可以实现潜在的改进。安装风力发电场将分别导致 NRPE 资源开发和 GHG 排放减少约 56%和 85%。最后,尽管水和 NRPE 资源的大量消耗以及由此产生的 GHG 排放,但再生 LDPE 颗粒的生产比原始 LDPE 颗粒更具可持续性。