Suppr超能文献

简报:奶牛的乳头管壁直径和乳头组织厚度受乳腺内压和机器挤奶的机械力影响。

Short communication: Teat wall diameter and teat tissue thickness in dairy cows are affected by intramammary pressure and by the mechanical forces of machine milking.

机构信息

Veterinary Physiology, Vetsuisse Faculty, University of Bern, Switzerland 3012.

Swedish University of Agricultural Sciences, Uppsala 75007, Sweden.

出版信息

J Dairy Sci. 2020 Jan;103(1):884-889. doi: 10.3168/jds.2019-16565. Epub 2019 Nov 14.

Abstract

The objective of this study was to validate and apply 2 different methods to record changes in teat tissue related to machine milking. Teat wall diameter was measured via B-mode ultrasound cross sectioning with a 7.5-MHz linear probe. Teat tissue thickness was measured using a cutimeter (spring-loaded caliper, spring constant 6.5 N/cm, 0.5 N at closed jaws). Both methods were applied at the teat barrel, 2 cm above the teat tip. In experiment 1, 24 teats from freshly slaughtered cows were used to perform ultrasound imaging (12 teats) or cutimeter measurements (12 teats) while the teat cisterns were filled with water to increase the intracisternal pressure from 0 to 30 kPa in steps of 1 kPa. Teat tissue thickness did not change at an intracisternal pressure from 0 to 10 kPa but increased with intracisternal pressure at levels >10 kPa. In contrast, teat wall diameter decreased with intracisternal pressure between 0 and 7 kPa but did not significantly change at a pressure ≥7 kPa up to 30 kPa. Significant Pearson correlation coefficients between intracisternal pressure and teat wall diameter were observed from 0 to 7 kPa (r = -0.38), and between intracisternal pressure and teat tissue thickness from 10 to 30 kPa (r = 0.45). In experiment 2, ultrasound and cutimeter measurements were performed in 12 lactating Holstein cows. Measurements before and during milking, immediately after cluster removal, with normal milking or with a 5-min overmilking, were performed and continued at 5-min intervals for 60 min and at 10-min intervals until 120 min. Additionally, with the 5-min overmilking treatment, measurements were continued at 60-min intervals up to 10 h after milking. Teat wall diameter decreased in response to milk ejection, followed by a continuous increase during the course of milking, with highest values after 5 min overmilking. Teat tissue thickness did not change during milking but was significantly increased after overmilking. Teat wall diameter and teat tissue thickness recovered to premilking levels within 35 min after normal milking and within 60 min after overmilking. Until 10 h after overmilking, the teat wall diameter decreased steadily, whereas teat tissue thickness was unfluctuating. In the physiologically relevant range of intramammary pressure, ultrasound measurements of the teat wall were affected by both intramammary pressure and mechanical forces, whereas cutimeter measurements were not affected by the intramammary pressure.

摘要

本研究的目的是验证和应用 2 种不同的方法来记录与机器挤奶相关的乳头组织变化。通过使用 7.5MHz 线性探头的 B 型超声横截面测量乳头壁直径。使用测径器(弹簧加载卡尺,弹簧常数 6.5N/cm,闭合钳口时为 0.5N)测量乳头组织厚度。这两种方法都在乳头桶部(乳头尖端上方 2cm)进行应用。在实验 1 中,使用来自刚宰杀的奶牛的 24 个乳头进行超声成像(12 个乳头)或测径器测量(12 个乳头),同时将乳头蓄水池充满水,以将腔内压力从 0 增加到 30kPa,步长为 1kPa。乳头组织厚度在腔内压力为 0 到 10kPa 时没有变化,但在腔内压力大于 10kPa 时增加。相比之下,乳头壁直径在腔内压力为 0 到 7kPa 之间减小,但在腔内压力≥7kPa 时直到 30kPa 时没有显著变化。在 0 到 7kPa 之间观察到腔内压力和乳头壁直径之间存在显著的 Pearson 相关系数(r=-0.38),在 10 到 30kPa 之间观察到腔内压力和乳头组织厚度之间存在显著的 Pearson 相关系数(r=0.45)。在实验 2 中,对 12 头泌乳荷斯坦奶牛进行了超声和测径器测量。在挤奶前和挤奶过程中、在挤奶后立即进行了测量,并在 60 分钟内每隔 5 分钟、在 120 分钟内每隔 10 分钟进行测量,直至 10 小时。此外,在 5 分钟超挤奶处理中,在挤奶后每隔 60 分钟进行测量,直至挤奶后 10 小时。乳头壁直径响应于奶液射出而减小,随后在挤奶过程中持续增加,在超挤奶 5 分钟后达到最高值。在挤奶过程中,乳头组织厚度没有变化,但在超挤奶后显著增加。在正常挤奶后 35 分钟内和超挤奶后 60 分钟内,乳头壁直径和乳头组织厚度恢复到挤奶前水平。在超挤奶后 10 小时内,乳头壁直径持续稳定下降,而乳头组织厚度保持不变。在与生理相关的乳腺内压范围内,超声测量的乳头壁既受到乳腺内压的影响,也受到机械力的影响,而测径器测量则不受乳腺内压的影响。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验