Suppr超能文献

[无牙颌患者鼻唇角侧方视野敏感度阈值变化]

[Visual sensitivity threshold of lateral view of nasolabial Angle changes in edentulous jaw patients].

作者信息

You L, Deng K H, Li W W, Zhao Y J, Sun Y C, Zhou Y S

机构信息

Department of Prosthodontics, Peking University School and Hospital of Stomatology & National Clinical Research Center for Oral Diseases & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China.

Center of Digital Dentistry, Peking University School and Hospital of Stomatology & National Clinical Research Center for Oral Diseases & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China.

出版信息

Beijing Da Xue Xue Bao Yi Xue Ban. 2020 Feb 18;52(1):107-112. doi: 10.19723/j.issn.1671-167X.2020.01.017.

Abstract

OBJECTIVE

To study the visual sensitivity threshold of physician's naked eye to the difference of nasolabial angle in edentulous jaw patients, and to provide a reference value for the study of aesthetic evaluation of soft tissue profile for the difference of nasolabial angle that can be recognized by human eyes.

METHODS

Three-dimensional facial images of three edentulous patients with different diagnostic dentures introoral were obtained. Lateral screenshots of each patient's three-dimensional facial image with the same scale were obtained by using reverse engineering software (Geomagic studio 2014).The screenshot of the patient's three-dimensional facial image with suitable lip support (The suitable lip support was confirmed by both patients and prosthodontists who had clinical experience for more than 20 years) was taken as the reference picture, and the remaining pictures were grouped with it respectively. All the pictures were observed in random order by the subjects. Fifteen dentists were asked to judge the difference of nasolabial angle between the two pictures of each group on the computer screen. The difference of nasolabial angle between the two pictures in each group was measured and calculated. The ROC curve was drawn, and the best cut-off value was calculated as the visual sensitivity threshold.

RESULTS

The data of the 15 subjects were used to draw ROC curves separately. The maximum and minimum best cut-off values were 5.55 degrees and 3.12 degrees respectively. The ROC curve of the whole 15 subjects was drawn after data aggregation, and the best cut-off value was 5.36 degrees (AUC=0.84>0.5, P=0.000<0.05). When the difference of nasolabial angle was above 5.36 degrees, the subjects could recognize it effectively.

CONCLUSION

There is a visual limit in the observation of the nasolabial angle with the naked eye. In this study, a visual sensitivity threshold of 5.36 degrees for the difference of the nasolabial angle was obtained. The difference of nasolabial angle below this value can be regarded as no clinical significance. This result provides a reference value for human eyes to recognize the difference of nasolabial angle in soft tissue profile aesthetic evaluation. It can be applied to the aesthetic evaluation of soft tissue profile and can be used as the error level of related research with nasolabial angle as an index for accuracy evaluation.

摘要

目的

研究医师肉眼对无牙颌患者鼻唇角差异的视觉敏感度阈值,为肉眼可识别的鼻唇角差异软组织侧貌美学评价研究提供参考值。

方法

获取3例佩戴不同诊断义齿的无牙颌患者的三维面部图像。使用逆向工程软件(Geomagic studio 2014)获取每位患者三维面部图像的等比例侧截图。将患者具有合适唇部支撑(由患者和有20多年临床经验的口腔修复医师共同确认合适的唇部支撑)的三维面部图像截图作为参考图片,其余图片分别与之分组。所有图片由受试者随机顺序观察。邀请15名牙医在电脑屏幕上判断每组两张图片之间的鼻唇角差异。测量并计算每组两张图片之间的鼻唇角差异。绘制ROC曲线,并计算最佳截断值作为视觉敏感度阈值。

结果

分别用15名受试者的数据绘制ROC曲线。最佳截断值的最大值和最小值分别为5.55度和3.12度。数据汇总后绘制15名受试者整体的ROC曲线,最佳截断值为5.36度(AUC = 0.84>0.5,P = 0.000<0.05)。当鼻唇角差异大于5.36度时,受试者能够有效识别。

结论

肉眼观察鼻唇角存在视觉限度。本研究得出鼻唇角差异的视觉敏感度阈值为5.36度。低于此值的鼻唇角差异可认为无临床意义。该结果为肉眼识别软组织侧貌美学评价中鼻唇角差异提供了参考值。可应用于软组织侧貌美学评价,并可作为以鼻唇角为指标进行准确性评价的相关研究的误差水平。

相似文献

本文引用的文献

6
Three-dimensional Nasolabial Morphologic Alterations Following Le Fort I.Le Fort I型截骨术后鼻唇区的三维形态学改变
Plast Reconstr Surg Glob Open. 2016 Aug 17;4(8):e848. doi: 10.1097/GOX.0000000000000685. eCollection 2016 Aug.
8
Virtual evaluation for CAD-CAM-fabricated complete dentures.计算机辅助设计与制造(CAD-CAM)制作全口义齿的虚拟评估
J Prosthet Dent. 2017 Jan;117(1):28-33. doi: 10.1016/j.prosdent.2016.05.015. Epub 2016 Aug 1.

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验