Wang P, Li D J, Liu J Z
Department of Prosthodontics, Peking University School and Hospital of Stomatology & National Clinical Research Center for Oral Diseases & National Engineering Laboratory for Digital and Material Technology of Stomatology & Beijing Key Laboratory of Digital Stomatology, Beijing 100081, China.
Department of Prosthodontics, Dalian Stomatological Hospital, Dalian 116021, Liaoning, China.
Beijing Da Xue Xue Bao Yi Xue Ban. 2020 Feb 18;52(1):124-128. doi: 10.19723/j.issn.1671-167X.2020.01.020.
To analyze the relationship between the width of the maxillary anterior teeth and the anterior arch perimeter, to analyze the change rule of the width of the anterior teeth and the anterior arch perimeter, when altered the convexity of the anterior arch, with the width of the maxillary anterior arch keeping constant, and to provide a reliable basis for later digitized and personalized aesthetic analysis of front teeth.
In the study, 61 front teeth complete and well-arranged models had been selected from the working models after the prostheses in Department of Prosthodontics, Peking University School and Hospital of Stomatology, including 22 male models and 39 female models. A photograph was taken from the occlusal surface of each model using the fixed magnification with a single lens reflex camera. The width of anterior teeth, the width of anterior arch and the convexity of anterior arch had been measured using the Photoshop software. The ratio of the width of the anterior teeth to the width of the anterior arch was calculated. Keeping the width of anterior arch unchanged, the layer free transformation function used to add or decrease the curvature of the anterior arch from 1-5 mm, each circumference of the anterior arch was measured. According to the proportion of their anterior teeth in the anterior arch perimeter, the width of each anterior teeth crown under different convexities of anterior arch was calculated. SPSS 23.0 was used to analyze the ratio of the width anterior teeth to the anterior arch perimeter and correlation between the convexity of the anterior arch and the width of the anterior teeth.
The percentages of the median length of the anterior arch in the central incisor, lateral incisor and canine were 36.2%±1.3%, 30.2%±1.5%, and 33.6%±1.4%, respectively. The proportions were normal distributions and not related to the perimeter of the anterior arch. When the width of the anterior arch was constant, there was a positive correlation between the convexity of anterior arch in the range of 5 mm and the width of anterior teeth or the front arch circumference. With each increase or decrease of 1 mm of the convexity of anterior arch, the width of the middle incisor increased or decreased by about 0.18 mm, the half circumference of the anterior arch increased or decreased by about 0.50 mm.
The width of the anterior teeth in the middle-distal direction remained stable in the anterior arch circumference. Within a certain range, when the width of the maxillary anterior arch remains unchanged, the width of the anterior teeth and the perimeter of the anterior teeth are positively correlated to the convexity of the anterior arch.
分析上颌前牙宽度与前牙弓周长的关系,探讨在前牙弓宽度保持不变的情况下,改变前牙弓凸度时前牙宽度及前牙弓周长的变化规律,为后期前牙数字化、个性化美学分析提供可靠依据。
本研究选取北京大学口腔医学院口腔修复科患者工作模型上的61个前牙完整、排列整齐的模型,其中男性模型22个,女性模型39个。用单镜头反光相机固定放大倍数后从每个模型的咬合面拍照。利用Photoshop软件测量前牙宽度、前牙弓宽度及前牙弓凸度,并计算前牙宽度与前牙弓宽度的比值。在前牙弓宽度不变的情况下,利用图层自由变换功能将前牙弓凸度增减1 - 5 mm,测量每次变换后前牙弓周长,并根据前牙在牙弓周长中的比例计算不同前牙弓凸度下各前牙冠宽度。采用SPSS 23.0软件分析前牙宽度与前牙弓周长的比值以及前牙弓凸度与前牙宽度的相关性。
前牙弓中线长度在中切牙、侧切牙及尖牙处的占比分别为36.2%±1.3%、30.2%±1.5%、33.6%±1.4%,该比例呈正态分布,与前牙弓周长无关。当前牙弓宽度不变时,前牙弓凸度在5 mm范围内与前牙宽度或前牙弓周长呈正相关。前牙弓凸度每增减1 mm,中切牙宽度约增减0.18 mm,前牙弓半周长约增减0.50 mm。
在前牙弓周长范围内,前牙在近远中方向的宽度保持稳定。在一定范围内,当上颌前牙弓宽度不变时,前牙宽度及前牙周长与前牙弓凸度呈正相关。