Edd Shannon N, Bennour Sami, Ulrich Baptiste, Jolles Brigitte M, Favre Julien
Department of Musculoskeletal Medicine, Swiss BioMotion Lab, Lausanne University Hospital and University of Lausanne (CHUV-UNIL), Lausanne CH-1011, Switzerland.
Department of Musculoskeletal Medicine, Swiss BioMotion Lab, Lausanne University Hospital and University of Lausanne (CHUV-UNIL), Lausanne CH-1011, Switzerland; Mechanical Laboratory of Sousse, National Engineering School of Sousse, University of Sousse, Sousse 4054, Tunisia.
J Biomech Eng. 2020 Jul 1;142(7). doi: 10.1115/1.4046713.
The purpose of this study was to determine the effects of modifying stride length (SL) on knee adduction and flexion moments, two markers of knee loading associated with medial-compartment knee osteoarthritis (OA) progression. This study also tested if SL modifications, in addition to foot progression angle (FP) and step width (SW) modifications, provide solutions in more subjects for reducing knee adduction moment (KAM) without increasing knee flexion moment (KFM), potentially protecting the joint. Fourteen healthy subjects (six female) were enrolled in this preliminary study. Walking trials were collected first without instructions, and then following foot placement instructions for 50 combinations of SL, FP, and SW modifications. Repeated measures analysis of variance was used to detect group-average effects of footprint modifications on maximum KAM and KFM and on KAM impulse. Subject-specific dose-responses between footprint modifications and kinetics changes were modeled with linear regressions, and the models were used to identify modification solutions, per subject, for various kinetics change conditions. Shorter SL significantly decreased the three kinetics measures (p < 0.01). Potential solutions for 10% reductions in maximum KAM and KAM impulse without increasing maximum KFM were identified for five subjects with FP and SW modifications. A significantly higher proportion of subjects had solutions when adding SL modifications (11 subjects, p = 0.04). In conclusion, SL is a valuable parameter to modify, especially in combination with FP and SW modifications, to reduce markers of medial knee loading. Future work is needed to extend these findings to osteoarthritic knees.
本研究的目的是确定改变步长(SL)对膝关节内收和屈曲力矩的影响,这两个膝关节负荷指标与内侧间室膝关节骨关节炎(OA)的进展相关。本研究还测试了除足部前进角度(FP)和步宽(SW)改变外,改变SL是否能为更多受试者提供解决方案,以在不增加膝关节屈曲力矩(KFM)的情况下降低膝关节内收力矩(KAM),从而可能保护关节。14名健康受试者(6名女性)参与了这项初步研究。首先在没有指导的情况下收集步行试验数据,然后按照足部放置指导,对SL、FP和SW改变的50种组合进行试验。采用重复测量方差分析来检测足迹改变对最大KAM和KFM以及KAM冲量的组平均效应。用线性回归对足迹改变与动力学变化之间的个体特异性剂量反应进行建模,并使用这些模型为每个受试者确定各种动力学变化条件下的改变解决方案。较短的SL显著降低了这三个动力学指标(p < 0.01)。对于5名受试者,通过改变FP和SW,确定了在不增加最大KFM的情况下使最大KAM和KAM冲量降低10%的潜在解决方案。当增加SL改变时,有解决方案的受试者比例显著更高(11名受试者,p = 0.04)。总之,SL是一个值得改变的有价值参数,特别是与FP和SW改变相结合时,可降低膝关节内侧负荷指标。需要进一步的研究将这些发现扩展到骨关节炎膝关节。