Kovačić Marin, Perović Klara, Papac Josipa, Tomić Antonija, Matoh Lev, Žener Boštjan, Brodar Tomislav, Capan Ivana, Surca Angelja K, Kušić Hrvoje, Štangar Urška Lavrenčič, Lončarić Božić Ana
Faculty of Chemical Engineering and Technology, University of Zagreb, Marulićev trg 19, HR-10000 Zagreb, Croatia.
Faculty of Chemistry and Chemical Technology, University of Ljubljana, Večna pot 113, SI-1000 Ljubljana, Slovenia.
Materials (Basel). 2020 Apr 1;13(7):1621. doi: 10.3390/ma13071621.
Sulfur-doped TiO (S-TiO) composites with reduced graphene oxide (rGO), wt. % of rGO equal to 0.5%, 2.75%, and 5.0%, were prepared by a one-pot solvothermal procedure. The aim was to improve photocatalytic performance in comparison to TiO under simulated solar irradiation for the treatment of diclofenac (DCF) in aqueous medium. The obtained composites were characterized for physical-chemical properties using thermogravimetric analysis (TGA), X-ray diffractograms (XRD), Raman, scanning electron microscopy (SEM)/energy dispersive X-ray (EDX), Brauner Emmett Teller (BET), and photoluminescence (PL) analyses, indicating successful sulfur doping and inclusion of rGO. Sulfur doping and rGO have successfully led to a decrease in photogenerated charge recombination. However, both antagonistic and synergistic effects toward DCF treatment were observed, with the latter being brought forward by higher wt.% rGO. The composite with 5.0 wt.% rGO has shown the highest DCF conversion at pH 4 compared to that obtained by pristine TiO, despite lower DCF adsorption during the initial dark period. The expected positive effects of both sulfur doping and rGO on charge recombination were found to be limited because of the subpar interphase contact with the composite and incomplete reduction of the GO precursor. Consequent unfavorable interactions between rGO and DCF negatively influenced the activity of the studied S-TiO/rGO photocatalyst under simulated solar irradiation.
采用一锅法溶剂热法制备了还原氧化石墨烯(rGO)质量分数分别为0.5%、2.75%和5.0%的硫掺杂二氧化钛(S-TiO)复合材料。目的是在模拟太阳辐射下,与TiO相比,提高其在水介质中处理双氯芬酸(DCF)的光催化性能。使用热重分析(TGA)、X射线衍射图(XRD)、拉曼光谱、扫描电子显微镜(SEM)/能量色散X射线(EDX)、布伦auer Emmett Teller(BET)和光致发光(PL)分析对所得复合材料的物理化学性质进行了表征,表明成功实现了硫掺杂并包含了rGO。硫掺杂和rGO成功地导致了光生电荷复合的减少。然而,观察到对DCF处理既有拮抗作用又有协同作用,后者由较高质量分数的rGO促成。与原始TiO相比,含5.0质量分数rGO的复合材料在pH值为4时显示出最高的DCF转化率,尽管在初始暗期的DCF吸附较低。由于与复合材料的界面接触不佳以及GO前驱体还原不完全,硫掺杂和rGO对电荷复合的预期积极作用被发现是有限的。rGO与DCF之间随后产生的不利相互作用对所研究的S-TiO/rGO光催化剂在模拟太阳辐射下的活性产生了负面影响。