Department of Orthopedic Surgery, University of Minnesota, 2512 South 7th St, Suite R200, Minneapolis, MN, USA.
Department of Orthopedic Surgery, University of Minnesota, 2512 South 7th St, Suite R200, Minneapolis, MN, USA.
Spine J. 2020 Oct;20(10):1685-1691. doi: 10.1016/j.spinee.2020.05.099. Epub 2020 May 20.
CONTEXT Intraoperative three-dimensional (3D) computed tomography (CT) imaging has become increasingly popular in spine surgery. Previous spine surgeon radiation exposure research has focused largely on procedures using fluoroscopy, however, few studies have been performed on the subject since the introduction of the 3D imaging systems. As a result, concerns have re-emerged over surgeon radiation exposure and the effectiveness of operating room (OR) protocols for decreasing workplace radiation. Current radiation safety guidelines require surgeons wear full body protective lead while any type of radiation is being administered during surgery. As a result, local institutions do not allow for the use of free-standing lead shields for sole radiation protection in the operating room. However, there is no data available to demonstrate whether the additional personal lead is required, or if in fact the lead shield alone is sufficient.
This study investigated the effectiveness of a free-standing lead shield in reducing spine surgeon radiation exposure in the operating room during intraoperative imaging.
STUDY DESIGN/SETTING: A prospective clinical research study at a large, tertiary care center.
Twenty-seven patients undergoing instrumented spinal procedures between June and August 2019.
Fluoroscopy time, total fluoroscopy dose delivered, 3D dose delivered, total 3D spins, number of HD spins, number of standard spins, number of fluoroscopic images, number of spine levels operated on, patient size setting, shield distance from patient, radiation dose in front of shield, radiation dose behind shield.
Twenty-seven instrumented spinal procedures using the O-Arm Imaging System (Medtronic, Minneapolis, MN) were observed to determine radiation exposure to a spine surgeon standing behind a lead shield in the OR. Two thermoluminescent dosimeters were used to measure scatter radiation in front of and behind lead shields. Both fluoroscopy and intraoperative CT based radiation exposure was recorded. The dosimeter readings were compared to determine the degree of radiation attenuation by the lead shield. Regression analysis of the exposure values from behind the shield, shield distance from the patient, and radiation dose delivered by the imaging system was utilized to estimate the number of cases required to surpass annual exposure limits. Case numbers were calculated for the highest "worst case" and "average case" exposure values. The safe annual occupation exposure limit determined by the National Council on Radiation Protection is five roentgen equivalent man (rem) or 50,000 microsieverts (μSv).
Average surgeon radiation exposure per case was 0.694 μSv (SD: 0.501, Range: 0.105-2.167) behind the lead shield compared to 14.577 μSv (SD: 9.864, Range: 2.185-44.492) in front of the lead shield. The average radiation dose reduction by the lead shield was 13.962 μSv (SD: 9.49, Range: 2.08-42.72) per case, which is equivalent to an average of 95.65% (SD: 1.71) radiation attenuation by lead shielding. If surgeons stand behind lead shields in the OR, the annual number of 3D image-guided spinal procedures required to surpass exposure limits is 15,479 and 67,060 based on "worst case" and "average case" analyses, respectively.
Our study demonstrates standing behind intraoperative lead shields is very effective at decreasing radiation exposure to surgeons. Additionally, surgeon radiation doses behind lead shielding fall far below annual exposure limits. Surgeons should not need additional protective equipment when a lead shield is used.
语境 术中三维(3D)计算机断层扫描(CT)成像在脊柱外科中越来越受欢迎。以前的脊柱外科医生辐射暴露研究主要集中在使用透视的手术上,但是,自从引入 3D 成像系统以来,很少有研究针对这一问题进行研究。因此,人们对手术医生的辐射暴露以及手术室(OR)协议降低工作场所辐射的有效性重新产生了担忧。目前的辐射安全指南要求外科医生在手术过程中使用全身防护铅,但任何类型的辐射都会被管理。因此,当地机构不允许在手术室中仅使用独立的铅屏蔽来进行单独的辐射防护。但是,没有数据表明是否需要额外的个人铅,或者实际上单独使用铅屏蔽是否足够。
本研究旨在调查术中成像时,独立铅屏蔽在减少脊柱外科医生在手术室中的辐射暴露方面的有效性。
研究设计/设置:在一家大型三级护理中心进行的前瞻性临床研究。
2019 年 6 月至 8 月期间接受器械性脊柱手术的 27 例患者。
透视时间,透视剂量,3D 剂量,总 3D 旋转次数,高清旋转次数,标准旋转次数,透视图像数量,操作的脊柱水平数量,患者体型设置,屏蔽与患者的距离,屏蔽前的辐射剂量,屏蔽后的辐射剂量。
观察了 27 例使用 O-Arm 成像系统(美敦力,明尼苏达州明尼阿波利斯)进行的器械性脊柱手术,以确定站在 OR 中的铅屏蔽后面的脊柱外科医生的辐射暴露情况。使用两个热释光剂量计测量屏蔽前后的散射辐射。同时记录透视和术中 CT 辐射暴露情况。比较剂量计读数以确定铅屏蔽的衰减程度。利用屏蔽后辐射暴露值,屏蔽与患者的距离以及成像系统的辐射剂量的回归分析,估计超过年度暴露限制所需的病例数。为最高的“最坏情况”和“平均情况”暴露值计算病例数。国家辐射防护委员会确定的安全年度职业暴露限值为 5 伦琴等效人(rem)或 50,000 微西弗(μSv)。
与屏蔽前的 14.577μSv(SD:9.864,范围:2.185-44.492)相比,屏蔽后的平均手术医生辐射暴露为 0.694μSv(SD:0.501,范围:0.105-2.167)。屏蔽后平均辐射剂量降低 13.962μSv(SD:9.49,范围:2.08-42.72),相当于铅屏蔽的平均辐射衰减率为 95.65%(SD:1.71)。如果外科医生在 OR 中站在铅屏蔽后面,那么根据“最坏情况”和“平均情况”分析,每年需要进行 15,479 次和 67,060 次 3D 图像引导的脊柱手术才能超过暴露限制。
我们的研究表明,术中铅屏蔽后面的站立位置非常有效地减少了外科医生的辐射暴露。此外,铅屏蔽后面的外科医生辐射剂量远低于年度暴露限制。当使用铅屏蔽时,外科医生不需要额外的防护设备。