Penghe Zhao, Yuling Liu, Chuanchuan Dou, Pengliang Wan
Institute of Water Resources and Hydro-Electric Engineering, Xi'an University of Technology, Xi'an 710048, China.
ACS Omega. 2020 Oct 1;5(40):26101-26109. doi: 10.1021/acsomega.0c03606. eCollection 2020 Oct 13.
To investigate the dissolution characteristics of low-temperature thermal pretreatment conditions and the process of sludge fermentation to produce acid, the influence of thermal pretreatment temperature on the dissolution of excess sludge organic composition and the mechanism of cell crushing of sludge thermal pretreatment were analyzed by an experimental method, and the performance of acid production was explored by sludge fermentation after pretreatment at different temperatures. The performance of acid production by sludge fermentation after pretreatment at different temperatures was measured. The results proved that the soluble chemical oxygen demand (SCOD) shows the largest increase in dissolution rate (11.92%) at 70 °C and in dissolution quantity (6518.33 mg/L) at 90 °C. However, at 80 °C, the solubility of total organic carbon (TOC) is the highest (3224.47 mg/L), and at 70 °C, the best dissolution conditions for soluble carbohydrate (SC) and soluble protein (SP) reached 340.07 and 80.92 mg/L, respectively. The degree of sludge breaking starts to increase at 70 °C. Correlation analysis shows that dissolved organic matter is mainly derived from the cell wall and intracellular material and SP is mainly derived from intracellular material. Excitation-emission matrix spectra and parallel factor analysis (EEM-PARAFAC) divides the sludge dissolved organic matter (DOM) into five fluorescent components, including C1 (318/366) tyrosine, C2 (418/470) UVA humic acid, C3 (282/334) tryptophan substances, C4 (322/430) UVC humic acids, and C5 (314, 382, 454/526) UVA humic substances. Fermentation acid production experiment shows that the peak concentration is highest at 80 °C, the arrival time is 2 days, and the acid production type is butyric acid fermentation. Thus, it is proved that low-temperature thermal pretreatment promotes the process of acid-producing fermentation and has no effect on the type of fermentation. The optimal condition for hydrolytic dissolution and acid production under low-temperature thermal pretreatment is 80 °C.
为研究低温热预处理条件下的溶解特性及污泥发酵产酸过程,通过实验方法分析了热预处理温度对剩余污泥有机成分溶解的影响及污泥热预处理细胞破碎机理,并对不同温度预处理后的污泥发酵产酸性能进行了探究。测定了不同温度预处理后污泥发酵产酸性能。结果表明,可溶性化学需氧量(SCOD)在70℃时溶解速率增加最大(11.92%),在90℃时溶解量最大(6518.33mg/L)。然而,在80℃时,总有机碳(TOC)的溶解度最高(3224.47mg/L),在70℃时,可溶性碳水化合物(SC)和可溶性蛋白质(SP)的最佳溶解条件分别达到340.07和80.92mg/L。污泥破碎程度在70℃时开始增加。相关性分析表明,溶解性有机物主要来源于细胞壁和细胞内物质,而SP主要来源于细胞内物质。激发发射矩阵光谱和平行因子分析(EEM-PARAFAC)将污泥溶解性有机物(DOM)分为五个荧光组分,包括C1(318/366)酪氨酸、C2(418/470)UVA腐殖酸、C3(282/334)色氨酸类物质、C4(322/430)UVC腐殖酸和C5(314、382、454/526)UVA腐殖质。发酵产酸实验表明,80℃时峰值浓度最高,到达时间为2天,产酸类型为丁酸发酵。由此证明,低温热预处理促进了产酸发酵过程,且对发酵类型无影响。低温热预处理下水解溶解和产酸的最佳条件为80℃。