Suppr超能文献

水力空化对增稠剩余污泥的增溶和生物可利用性的影响。

Effect of hydrodynamic disintegration on the solubilisation and bioavailability of thickened excess sludge.

机构信息

Department of Water Supply and Wastewater Treatment, Faculty of Building Services, Hydro and Environmental Engineering, Warsaw University of Technology, Nowowiejska 20, 00-653 Warsaw, PL, Poland.

出版信息

Ultrason Sonochem. 2020 Jun;64:105015. doi: 10.1016/j.ultsonch.2020.105015. Epub 2020 Feb 7.

Abstract

The main objective of the study was the verification whether conducting the hydrodynamic disintegration (HD) of thickened excess sludge (TES) before the anaerobic hydrolysis (AH) can cause an increase in the efficiency of the hydrolysis process, and therefore a reduction in its duration, or allow for complete omission of the stage before the anaerobic digestion (AD). For this purpose, the HD (conducted in five levels of energy density (E): 140, 280, 420, 560 and 700 kJ/L) of TES was carried out, and then all sludges (before and after disintegration) were subjected to the AH. The obtained results confirmed that the process of HD can be an effective method of increasing the solubilisation and bioavailability of TES. In the process of HD, the maximum increase in ΔVFA (308-428 mg VFA/L), was reported when E was increased from 140 to 280 kJ/L (the solubilisation degree increased from approximately 2 to 8%). The obtained results also showed that the ΔSTN and ΔSTP were related to solubilisation degree. The most intensive increase in the ΔSTN was determined for solubilisation degree in a range of 15-20%. In the case of ΔSTP, constant intensity of release of the compounds to the sludge liquid was observed. The obtained results also confirmed that conducting the process of AH of disintegrated TES proved to change the SCOD value when contrasted with the value of this indicator at the start of the experiment (before hydrolysis): (i) the E equal to 140 and 280 kJ/L allowed for a higher SCOD value; (ii) at E higher or equal to 560 kJ/L it caused a decrease in the SCOD value.

摘要

本研究的主要目的是验证在进行厌氧水解 (AH) 之前对增稠剩余污泥 (TES) 进行流体动力分解 (HD) 是否可以提高水解过程的效率,从而缩短其时间,或者可以完全省略厌氧消化 (AD) 之前的阶段。为此,进行了 TES 的 HD(在五个能量密度 (E) 水平下进行:140、280、420、560 和 700 kJ/L),然后对所有污泥(分解前后)进行 AH。所得结果证实,HD 过程可以是增加 TES 的溶解和生物可利用性的有效方法。在 HD 过程中,当 E 从 140 增加到 280 kJ/L 时,ΔVFA(308-428 mg VFA/L)的最大增加量报告为 308-428 mg VFA/L)(溶解程度从大约 2%增加到 8%)。所得结果还表明,ΔSTN 和 ΔSTP 与溶解程度有关。在 15-20%的溶解程度范围内,ΔSTN 的增加最为剧烈。就 ΔSTP 而言,观察到化合物向污泥液体的释放强度恒定。所得结果还证实,与实验开始时(水解前)的 SCOD 值相比,进行分解 TES 的 AH 过程证明可以改变 SCOD 值:(i) E 等于 140 和 280 kJ/L 时,SCOD 值较高;(ii) 在 E 高于或等于 560 kJ/L 时,SCOD 值降低。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验