Department of Mechanical & Aerospace Engineering, Carleton University, Ottawa, Canada.
Product Development, McArthur Medical Sales, Inc., Rockton, Canada.
J Aerosol Med Pulm Drug Deliv. 2021 Aug;34(4):242-250. doi: 10.1089/jamp.2019.1570. Epub 2020 Nov 10.
For patients with severe chronic obstructive pulmonary disease under invasive mechanical ventilation, medication for aerosol therapy is delivered through tracheostomy or endotracheal airways. Typically, these medications (such as bronchodilators) are long-acting formulations that are delivered through Soft Mist Inhalers (SMI), or Pressurized Metered-Dose Inhalers. The Respimat SMI has been shown to have increased efficiency because of its slow and prolonged aerosol mist and has gained popularity in clinical settings. However, the Respimat was not designed for drug delivery through artificial airways. Therefore, there is a need for SMI adapters in intensive care for use in mechanical ventilator circuits. The purpose of this study was to evaluate the performance of a new Respimat adapter (ODAPT for mechanical ventilator [ODAPT MV]) for use in mechanical ventilator circuits which, in combination with a Pulmodyne T-piece adapter, allows use without interruption of the circuit in case of medication replacement. Tiotropium delivery to the lungs, using Respimat, was assessed using the ODAPT MV adapter within an setup, including a three-dimensional printed trachea model and a mechanical ventilator. Medication deposition and losses were investigated using two commonly used tracheostomy tube (TT) sizes (6 and 8 mm inner canula) for two flow rates (45 and 60 L/min) under different conditions (30%-50%. and 100% relative humidity [RH]). Medication delivery using the ODAPT MV adapter was compared with the RTC-26C in-line adapter under similar conditions (8 mm TT size, 100% RH at 45 L/min). It was found that 7.1%-13.4% of the nominal dose (ND) was lost in the ODAPT MV adapter for different TT size, RH, and flow rates used. Higher losses were found in the inhaler's mouthpiece ranging from 15.7% to 29.1% ND. The percentage of the delivered medication reaching the lungs was determined to be 13.7%-18.5% ND delivered without significant differences between the experimental conditions tested. The ODAPT MV performed well compared with the RTC-26C under similar conditions (17.9% and 16.6% ND, respectively). The medication delivered through mechanical ventilation using the ODAPT MV adapter represents about one third the dose delivered directly through the Respimat SMI .
对于接受有创机械通气的严重慢性阻塞性肺疾病患者,通过气管造口或气管内气道输送用于气溶胶治疗的药物。通常,这些药物(如支气管扩张剂)是长效制剂,通过软雾吸入器(SMI)或压力计量剂量吸入器输送。由于其缓慢而持久的气溶胶雾,Respimat 已被证明具有更高的效率,并在临床环境中广受欢迎。然而,Respimat 并非专为通过人工气道输送药物而设计。因此,在重症监护中需要 SMI 适配器用于机械通气机回路。本研究的目的是评估一种新的 Respimat 适配器(机械通气机用 ODAPT [ODAPT MV])在机械通气机回路中的性能,该适配器与 Pulmodyne T 型件适配器结合使用,在更换药物时可无需中断回路即可使用。在设置中,包括三维打印的气管模型和机械通气机,使用 ODAPT MV 适配器评估了噻托溴铵通过 Respimat 输送到肺部的情况。使用两种常用的气管造口管(TT)尺寸(6 和 8 毫米内套管)和两种流速(45 和 60 L/min),在不同条件下(30%-50%和 100%相对湿度 [RH])下研究了药物沉积和损失。在类似条件下(8 毫米 TT 尺寸,45 L/min 时 100% RH),使用 ODAPT MV 适配器与 RTC-26C 在线适配器比较了药物输送情况。结果发现,在不同的 TT 尺寸、RH 和流速下,ODAPT MV 适配器损失的名义剂量(ND)为 7.1%-13.4%。在吸入器的吸嘴中发现更高的损失,范围为 15.7%至 29.1% ND。到达肺部的输送药物的百分比确定为无显著差异的实验条件下分别为 13.7%-18.5% ND 输送。在类似条件下,ODAPT MV 与 RTC-26C 相比表现良好(分别为 17.9%和 16.6% ND)。通过 ODAPT MV 适配器使用机械通气输送的药物代表通过 Respimat SMI 直接输送的药物剂量的三分之一左右。