Department of Instrument Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, China.
Schlegel Research Institute for Aging, University of Waterloo, Waterloo, ON N2L3G1, Canada.
Ultrason Sonochem. 2021 Apr;72:105400. doi: 10.1016/j.ultsonch.2020.105400. Epub 2020 Dec 2.
Inertial cavitation (IC) of the preformed microbubbles is being investigated for ultrasound imaging and therapeutic applications. However, microbubbles rupture during IC, creating smaller daughter bubbles (DBs), which may cause undesired bioeffects in the target region. Thus, it is important to determine the properties of DBs to achieve controllable cavitation activity for applications. In this study, we theoretically calculated the dissolution dynamics of sulfur hexafluoride bubbles. Then, we applied a 1-MHz single tone burst with different peak negative pressures (PNPs) and pulse lengths (PLs), and multiple 5-MHz tone bursts with fixed acoustic conditions to elicit IC of the preformed SonoVue microbubbles and scattering of DBs, respectively. After the IC and scattering signals were received by a 7.5-MHz transducer, time- and frequency-domain analysis was performed to obtain the IC dose and scattering intensity curve. The theoretical dissolution curves and measured scattering intensity curves were combined to determine the effect of the incident pulse parameters on the lifetime, mean radius and distribution range of DBs. Increased PNP reduced the lifetime and mean size of the DBs population and narrowed the size distribution. The proportion of small DBs (less than resonance size) increased from 36.83% to 85.98% with an increase in the PNP from 0.6 to 1.6 MPa. Moreover, increased PL caused a shift of the DB population to the smaller bubbles with shorter lifetime and narrower distribution. The proportion of small bubbles increased from 25.74% to 95.08% as the PL was increased from 5 to 100 µs. Finally, increased IC dose caused a smaller mean size, shorter lifetime and narrower distribution in the DB population. These results provide new insight into the relationship between the incident acoustic parameters and the properties of DBs, and a feasible strategy for achieving controllable cavitation activity in applications.
惰性空化(IC)的预形成微泡正在被研究用于超声成像和治疗应用。然而,微泡在 IC 过程中破裂,产生更小的子泡(DB),这可能会在目标区域引起不需要的生物效应。因此,确定 DB 的特性对于实现应用中的可控空化活性非常重要。在这项研究中,我们从理论上计算了六氟化硫气泡的溶解动力学。然后,我们应用了不同的峰值负压(PNP)和脉冲长度(PL)的 1MHz 单音脉冲,以及多个固定声条件的 5MHz 音脉冲,分别诱发预形成的 SonoVue 微泡的 IC 和 DB 的散射。在 IC 和散射信号被 7.5MHz 换能器接收后,进行了时频域分析,以获得 IC 剂量和散射强度曲线。将理论溶解曲线和测量散射强度曲线相结合,确定了入射脉冲参数对 DB 寿命、平均半径和分布范围的影响。增加 PNP 会降低 DB 种群的寿命和平均尺寸,并缩小尺寸分布。随着 PNP 从 0.6 增加到 1.6 MPa,小于谐振尺寸的小 DB 的比例从 36.83%增加到 85.98%。此外,增加 PL 会导致 DB 种群向寿命更短、分布更窄的小气泡转移。随着 PL 从 5 增加到 100 µs,小气泡的比例从 25.74%增加到 95.08%。最后,增加 IC 剂量会导致 DB 种群的平均尺寸更小、寿命更短、分布更窄。这些结果为入射声参数与 DB 特性之间的关系提供了新的见解,并为在应用中实现可控空化活性提供了可行的策略。