Suppr超能文献

重建的前交叉韧带移植物等长受股骨位置影响大于胫骨位置。

Medial collateral ligament reconstruction graft isometry is effected by femoral position more than tibial position.

机构信息

Department of Trauma, Hand and Reconstructive Surgery, Westphalian Wilhelms University Muenster, Muenster, Germany.

Avon Orthopaedic Centre, Bristol, UK.

出版信息

Knee Surg Sports Traumatol Arthrosc. 2021 Nov;29(11):3800-3808. doi: 10.1007/s00167-020-06420-8. Epub 2021 Jan 17.

Abstract

PURPOSE

The purpose of this study was to examine the length change patterns of the native medial structures of the knee and determine the effect on graft length change patterns for different tibial and femoral attachment points for previously described medial reconstructions.

METHODS

Eight cadaveric knee specimens were prepared by removing the skin and subcutaneous fat. The sartorius fascia was divided to allow clear identification of the medial ligamentous structures. Knees were then mounted in a custom-made rig and the quadriceps muscle and the iliotibial tract were loaded, using cables and hanging weights. Threads were mounted between tibial and femoral pins positioned in the anterior, middle, and posterior parts of the attachment sites of the native superficial medial collateral ligament (sMCL) and posterior oblique ligament (POL). Pins were also placed at the attachment sites relating to two commonly used medial reconstructions (Bosworth/Lind and LaPrade). Length changes between the tibiofemoral pin combinations were measured using a rotary encoder as the knee was flexed through an arc of 0-120°.

RESULTS

With knee flexion, the anterior fibres of the sMCL tightened (increased in length 7.4% ± 2.9%) whilst the posterior fibres slackened (decreased in length 8.3% ± 3.1%). All fibre regions of the POL displayed a uniform lengthening of approximately 25% between 0 and 120° knee flexion. The most isometric tibiofemoral combination was between pins placed representing the middle fibres of the sMCL (Length change = 5.4% ± 2.1% with knee flexion). The simulated sMCL reconstruction that produced the least length change was the Lind/Bosworth reconstruction with the tibial attachment at the insertion of the semitendinosus and the femoral attachment in the posterior part of the native sMCL attachment side (5.4 ± 2.2%). This appeared more isometric than using the attachment positions described for the LaPrade reconstruction (10.0 ± 4.8%).

CONCLUSION

The complex behaviour of the native MCL could not be imitated by a single point-to-point combination and surgeons should be aware that small changes in the femoral MCL graft attachment position will significantly effect graft length change patterns. Reconstructing the sMCL with a semitendinosus autograft, left attached distally to its tibial insertion, would appear to have a minimal effect on length change compared to detaching it and using the native tibial attachment site. A POL graft must always be tensioned near extension to avoid capturing the knee or graft failure.

摘要

目的

本研究旨在探讨膝关节内侧结构的长度变化模式,并确定不同胫骨和股骨附着点对先前描述的内侧重建的移植物长度变化模式的影响。

方法

准备 8 个尸体膝关节标本,去除皮肤和皮下脂肪。切开股四头肌筋膜,以清楚识别内侧韧带结构。将膝关节安装在定制的夹具中,使用电缆和悬挂重物加载股四头肌和阔筋膜张肌。在胫骨和股骨销钉之间安装线,这些销钉位于胫骨内侧副韧带(sMCL)和后斜韧带(POL)的附着部位的前、中、后部分。还在与两种常用的内侧重建(Bosworth/Lind 和 LaPrade)相关的附着部位放置销钉。当膝关节在 0-120°的弧形范围内弯曲时,使用旋转编码器测量胫骨-股骨销钉组合之间的长度变化。

结果

随着膝关节的弯曲,sMCL 的前纤维收紧(长度增加 7.4%±2.9%),而后纤维松弛(长度减少 8.3%±3.1%)。POL 的所有纤维区域在 0 到 120°膝关节弯曲之间显示出均匀的约 25%的伸长。最等长的胫骨-股骨组合是放置在 sMCL 中间纤维的销钉之间(膝关节弯曲时的长度变化为 5.4%±2.1%)。产生最小长度变化的模拟 sMCL 重建是 Lind/Bosworth 重建,胫骨附着在半腱肌的插入处,股骨附着在 sMCL 附着侧的后部(5.4±2.2%)。这似乎比使用 LaPrade 重建描述的附着位置更等长(10.0±4.8%)。

结论

单一的点对点组合无法模拟内侧结构的复杂行为,外科医生应该意识到,股骨内侧副韧带移植物附着位置的微小变化将显著影响移植物长度变化模式。用半腱肌自体移植物重建 sMCL,将其远端附着在其胫骨附着处,与将其分离并用胫骨固有附着点相比,对长度变化的影响似乎最小。POL 移植物必须始终在接近伸展的位置拉紧,以避免捕获膝关节或移植物失效。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/5577/8514388/3c6c01f43e7c/167_2020_6420_Fig1_HTML.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验