Department of Physical Therapy, Yamagata Prefectural University of Health Sciences, Yamagata, Japan.
Graduate School of Health Sciences, Yamagata Prefectural University of Health Sciences, Yamagata, Japan.
Surg Radiol Anat. 2021 May;43(5):653-659. doi: 10.1007/s00276-020-02674-6. Epub 2021 Jan 19.
The purpose of this study was to investigate if the three partitions (superior, middle, and inferior partitions) of the infraspinatus muscle previously described in anatomical studies will present different behavior during scapular plane abduction (scaption) as described using shear-wave elastography, especially during initial range of motion.
Eight volunteers held their arm against gravity 15° intervals from 30° to 150° in scaption. Shear-wave elastography was implemented at each position to measure shear modulus at rest and during muscle contraction, as a surrogate for muscle stiffness, of each partition. Muscle activity was defined as the difference in stiffness values between the resting positions and those during muscle contraction (ΔE = stiffness at contraction-stiffness at rest).
The activity value for the middle partition was 25.1 ± 10.8 kPa at 30° and increased up to 105° (52.2 ± 10.8 kPa), with a subsequent decrease at larger angle positions (p < .001). The superior partition showed a flatter and constant behavior with smaller activity values except at higher angles (p < .001). Peak activity values for the superior partition were observed at 135° (23.0 ± 12.0 kPa). Increase activity for inferior partition began at 60° and showed a peak at 135° (p < .001; 32.9 ± 13.8 kPa).
Stiffness measured using shear-wave elastography in each partition of the infraspinatus muscle demonstrated different behavior between these partitions during scaption. The middle partition generated force throughout scaption, while the superior and inferior partitions exerted force at end range.
本研究旨在探讨先前在解剖学研究中描述的肩胛下肌的三个分区(上、中、下分区)在肩胛平面外展(外展)过程中是否会表现出不同的行为,特别是在初始运动范围内。
8 名志愿者将手臂悬于重力下,每隔 15°从 30°到 150°进行外展。在每个位置使用剪切波弹性成像测量休息时和肌肉收缩时的剪切模量,作为肌肉僵硬的替代指标,用于测量每个分区的剪切模量。肌肉活动定义为静止位置与肌肉收缩时的僵硬值之间的差异(ΔE=收缩时的僵硬值-静止时的僵硬值)。
中分区的活动值在 30°时为 25.1±10.8 kPa,在 105°时增加到 52.2±10.8 kPa,在较大角度位置后下降(p<.001)。上分区表现出较平坦且稳定的行为,活动值较小,除在较高角度外(p<.001)。上分区的峰值活动值出现在 135°(23.0±12.0 kPa)。下分区的活动值从 60°开始增加,并在 135°时达到峰值(p<.001;32.9±13.8 kPa)。
使用剪切波弹性成像测量肩胛下肌各分区的刚度在肩胛平面外展过程中显示出这些分区之间的不同行为。中部分区在整个外展过程中产生力,而上部和下部分区在末端范围施加力。