Environment and Health Research Unit, South African Medical Research Council, Johannesburg, South Africa; University of KwaZulu-Natal, Discipline of Occupational and Environmental Health, School of Nursing and Public Health, Durban, South Africa.
Environment and Health Research Unit, South African Medical Research Council, Johannesburg, South Africa; Department of Environmental Health, Faculty of Health Sciences, University of Johannesburg, South Africa; School of Public Health, Faculty of Health Sciences, University of the Witwatersrand, Johannesburg, South Africa.
Sci Total Environ. 2020 Jan 10;699:134324. doi: 10.1016/j.scitotenv.2019.134324. Epub 2019 Sep 6.
Recycling of scrap metal into artisanal cookware is widespread in poorly resourced countries. The aim of the study was to determine the risk of metal exposure from the use of artisanal cookware available in South Africa. Twenty cookware samples were purchased from local manufacturers and informal traders across South Africa. Aluminum and silicon concentrations were determined using XRF and the total content of 18 elements (Ag, As, Ba, Cd, Co, Cr, Cu, Fe, Hg, Mn, Mo, Ni, Pb, Sb, Se, Sn, V and Zn) were evaluated using ICPMS. Leaching of metals from cut pieces of cookware over a 2-h period of boiling in a 3% acetic acid solution was repeated 3 times and revealed multi-metal migration that was compared to EU maximum permissible levels. The mean Al migration of 509 mg L was over 100 times the EU maximum permissible level allowed for cookware. Lead was detected in all samples with 11 (55%), 12 (60%) and 9 (45%) of samples being over the maximum EU permissible level (10 μg Pb L) for 1st, 2nd and 3rd migrations respectively. The mean As migration concentrations in the first leaching event ranged from 0.23 to 24.1 μg L with four pots (20%) over the maximum EU permissible limit for As (2 μg L). Notably, all four pots were well below the maximum EU permissible As limit by the 3rd migration. Cadmium and mercury were detected in each pot across all three migrations however the levels were relatively low. Transmission electron microscopy revealed dramatic changes in surface structure after leaching of cookware.
废旧金属回收再制成炊具在资源匮乏的国家很常见。本研究旨在确定南非市售炊具使用过程中金属暴露的风险。从南非当地制造商和非正规贸易商处购买了 20 个炊具样品。使用 XRF 测定铝和硅的浓度,并用 ICPMS 评估 18 种元素(Ag、As、Ba、Cd、Co、Cr、Cu、Fe、Hg、Mn、Mo、Ni、Pb、Sb、Se、Sn、V 和 Zn)的总量。将炊具切割后在 3%的乙酸溶液中煮沸 2 小时,重复 3 次,以评估金属的浸出情况,并与欧盟最大允许浓度进行比较。509mg/L 的平均 Al 迁移量超过欧盟允许的炊具最大允许浓度 100 多倍。所有样品中均检出 Pb,其中 11 个(55%)、12 个(60%)和 9 个(45%)样品的第 1、2 和 3 次迁移的 Pb 含量分别超过欧盟允许的最大浓度(10μg Pb/L)。第一次浸出时,As 的平均迁移浓度范围为 0.23 至 24.1μg/L,其中 4 个锅(20%)的 As 迁移浓度超过欧盟允许的最大浓度(2μg/L)。值得注意的是,到第 3 次迁移时,所有 4 个锅的 As 含量均远低于欧盟允许的最大浓度。在所有三次迁移中,每个锅都检测到 Cd 和 Hg,但浓度相对较低。透射电子显微镜显示,炊具浸出后表面结构发生了显著变化。