Assessment of a simple and replicable procedure for selective phosphorus recovery from sewage sludge ashes by wet chemical extraction and precipitation.

The selective phosphorus recovery by wet chemical extraction and precipitation was assessed at the laboratory scale aiming at identifying a simple and replicable procedure that could be effectively applied to different types of sewage sludge ashes. The experimental work was performed on five samples of sewage sludge ashes, of which three were obtained from muffle-furnace incineration and two from full-scale mono-incineration plants. A single-step extraction procedure has been investigated by applying different operating conditions (type of leaching acid, liquid-to-solid ratio, contact time). Experimental results indicated that phosphorus recovery efficiency varied between 54 and 92% with limited co-dissolution of metals and metalloids, except for arsenic. Operating conditions, sewage sludge ashes characteristics and phosphorus removal processes in the wastewater treatment plant were the main factors affecting phosphorus recovery efficiency. The application of optimal operating conditions (0.2 M sulfuric acid, liquid-to-solid ratio of 20 and contact time of 2 h) resulted in phosphorus recovery from 76 to 92% on four samples. Subsequently, precipitation of phosphorus from acidic leachate was carried out by lime dosing. After filtering and drying, the recovered products presented a PO content between 11.5 and 36.7% dry weight, with a fraction of soluble phosphorus between 75 and 91%, a good percentage for application as fertilizer or animal feed. Since few undesired elements (i.e., As, Cu and Zn) exceeded the limits for fertilizer application (exception was represented by Ni and Pb, which were present at low concentration), an additional purification step may be required. Overall, experimental results highlighted the influence of process parameters on phosphorus recovery.