Automatic flow delay through passive wax valves for paper-based analytical devices.

Microfluidic paper-based analytical devices (μPADs) have been widely explored for point-of-care testing due to their simplicity, low cost, and portability. μPADs with multiple-step reactions usually require precise flow control, especially flow-delay. This paper reports the numerical, mathematical, and experimental studies of flow delay through wax valves surrounded by PDMS walls on paper microfluidics. The predried surfactant in the sample zone diffuses into the liquid sample which can therefore flow through the wax valves. The delay time is automatically regulated by the diffusion of the surfactant after sample loading. The numerical study suggested that both the elevated contact angle and the reduced porosity and pore size in the wax printed region could effectively prevent water but allow liquids with lower contact angles (, surfactant solutions) to flow through. The PDMS walls fabricated using a low-cost liquid dispenser effectively prevented the leakage of surfactant solutions. By controlling the quantity, diffusion distance, and type of the surfactant predried on the chip, the system successfully achieved a delay time ranging from 1.6 to 20 minutes. A mathematical model involving the above parameters was developed based on Fick's second law to predict the delay time. Finally, the flow-delay systems were applied in sequential mixing and distance-based detection of either glucose or alcohol. Linear ranges of 1-100 mg dL and 1-40 mg dL were achieved for glucose and alcohol, respectively. The lower limit detection (LOD) of glucose and alcohol was 1 mg dL. The LOD of glucose was only 1/11 of that detected using μPADs without flow control, indicating the advantage of controlling fluid flow. The systematic findings in this study provide critical guidelines for the development and applications of wax valves in automatic flow delay for point-of-care testing.