Department of Radiology, Toyohashi Municipal Hospital, 50 Aza Hachiken Nishi, Aotake-Cho, Toyohashi, Aichi, 4418570, Japan.
Department of Quantum Medical Technology, Graduate School of Medical Sciences, Kanazawa University, 5-11-80 Kodatsuno, Kanazawa, Ishikawa, 9200942, Japan.
Ann Nucl Med. 2022 Feb;36(2):183-190. doi: 10.1007/s12149-021-01689-2. Epub 2021 Nov 3.
Although xSPECT Bone (xB) provides quantitative single-photon emission computed tomography (SPECT) high-resolution images, patients' burden remains high due to long acquisition time; therefore, this study aimed to investigate the feasibility of shortening the xB acquisition time using a custom-designed phantom.
A custom-designed xSPECT bone-specific (xSB) phantom with simulated cortical and spongious bones was developed based on the thoracic bone phantom. Both standard- and ultra-high-speed (UHS) xB acquisitions were performed in a male patient with lung cancer. In this phantom study, SPECT was acquired for 3, 6, 9, 12, and 30 min. The clinical SPECT acquisition time per rotation was 9 and 3 min for standard and UHS, respectively. SPECT images were reconstructed using ordered subset expectation maximization with three-dimensional resolution recovery (Flash3D; F3D) and xB algorithms. Quantitative SPECT value (QSV) and coefficient of variation (CV) were measured using the volume of interests (VOIs) placed at the center of the vertebral body and hot sphere. A linear profile was plotted on the spinous process at the center of the xSB phantom; then, the full width at half maximum (FWHM) was measured. The standardized uptake value (SUV) and standard deviation from the first thoracic to the fifth lumbar vertebrae in clinical standard- and UHS-xB images were measured using a 1-cm VOI.
The QSV of F3D images was underestimated even in large regions, whereas those of xB images were close to actual radioactivity concentration. The CV was similar or lower for xB images than that for F3D images but was not decreased with increasing acquisition time for both reconstruction images. The FWHM of xB images was lower than those of F3D images at all acquisition times. The mean SUV values from the first thoracic to fifth lumbar vertebrae for standard- and UHS-xB images were 6.73 ± 0.64 and 6.19 ± 0.87, respectively, showing a strong positive correlation.
Results of this phantom study suggest that xB imaging can be obtained in only one-third of the acquisition time without compromising the image quality. The SUV of UHS-xB images can be similar to that of standard-xB images in terms of clinical interpretation.
虽然 xSPECT Bone(xB)提供了定量单光子发射计算机断层扫描(SPECT)高分辨率图像,但由于采集时间长,患者的负担仍然很大;因此,本研究旨在探讨使用定制的体模缩短 xB 采集时间的可行性。
根据胸体模设计了一个具有模拟皮质骨和松质骨的定制 xSPECT 骨专用(xSB)体模。在一名肺癌男性患者中进行了标准和超高速度(UHS)xB 采集。在这项体模研究中,SPECT 采集时间分别为 3、6、9、12 和 30 分钟。标准和 UHS 的临床 SPECT 旋转采集时间分别为 9 和 3 分钟。使用三维分辨率恢复的有序子集期望最大化(Flash3D;F3D)和 xB 算法重建 SPECT 图像。使用放置在椎体中心的感兴趣区(VOI)测量 SPECT 值(QSV)和变异系数(CV)。在 xSB 体模中心的棘突上绘制线性轮廓,然后测量半峰全宽(FWHM)。使用 1cm VOI 测量临床标准和 UHS-xB 图像中第一胸椎到第五腰椎的标准化摄取值(SUV)和标准偏差。
即使在较大区域,F3D 图像的 QSV 也被低估,而 xB 图像的 QSV 接近实际放射性浓度。xB 图像的 CV 与 F3D 图像相似或更低,但对于两种重建图像,随着采集时间的增加,CV 并没有降低。在所有采集时间,xB 图像的 FWHM 均低于 F3D 图像。标准和 UHS-xB 图像从第一胸椎到第五腰椎的平均 SUV 值分别为 6.73±0.64 和 6.19±0.87,呈强正相关。
这项体模研究的结果表明,在不影响图像质量的情况下,xB 成像可以在三分之一的采集时间内获得。在临床解释方面,UHS-xB 图像的 SUV 值可以与标准-xB 图像相似。