Group of Atmospheric Science, Department of Computer Science, Electrical and Space Engineering, Luleå University of Technology, 97187 Luleå, Sweden.
Centro de Astrobiología (CSIC-INTA), Torrejón de Ardoz, 28850 Madrid, Spain.
Sensors (Basel). 2021 Nov 8;21(21):7421. doi: 10.3390/s21217421.
The water content of the upper layers of the surface of Mars is not yet quantified. Laboratory simulations are the only feasible way to investigate this in a controlled way on Earth, and then compare it with remote and in situ observations of spacecrafts on Mars. Describing the processes that may induce changes in the water content of the surface is critical to determine the present-day habitability of the Martian surface, to understand the atmospheric water cycle, and to estimate the efficiency of future water extraction procedures from the regolith for In Situ Resource Utilization (ISRU). This paper illustrates the application of the SpaceQ facility to simulate the near-surface water cycle under Martian conditions. Rover Environmental Monitoring Station (REMS) observations at Gale crater show a non-equilibrium situation in the atmospheric HO volume mixing ratio (VMR) at night-time, and there is a decrease in the atmospheric water content by up to 15 g/m within a few hours. This reduction suggests that the ground may act at night as a cold sink scavenging atmospheric water. Here, we use an experimental approach to investigate the thermodynamic and kinetics of water exchange between the atmosphere, a non-porous surface (LN-chilled metal), various salts, Martian regolith simulant, and mixtures of salts and simulant within an environment which is close to saturation. We have conducted three experiments: the stability of pure liquid water around the vicinity of the triple point is studied in experiment 1, as well as observing the interchange of water between the atmosphere and the salts when the surface is saturated; in experiment 2, the salts were mixed with Mojave Martian Simulant (MMS) to observe changes in the texture of the regolith caused by the interaction with hydrates and liquid brines, and to quantify the potential of the Martian regolith to absorb and retain water; and experiment 3 investigates the evaporation of pure liquid water away from the triple point temperature when both the air and ground are at the same temperature and the relative humidity is near saturation. We show experimentally that frost can form spontaneously on a surface when saturation is reached and that, when the temperature is above 273.15 K (0 °C), this frost can transform into liquid water, which can persist for up to 3.5 to 4.5 h at Martian surface conditions. For comparison, we study the behavior of certain deliquescent salts that exist on the Martian surface, which can increase their mass between 32% and 85% by absorption of atmospheric water within a few hours. A mixture of these salts in a 10% concentration with simulant produces an aggregated granular structure with a water gain of approximately 18- to 50-wt%. Up to 53% of the atmospheric water was captured by the simulated ground, as pure liquid water, hydrate, or brine.
火星表面上层的含水量尚未被量化。实验室模拟是在地球上以受控方式进行调查的唯一可行方法,然后可以将其与火星航天器的远程和原位观测进行比较。描述可能导致表面含水量变化的过程对于确定火星表面目前的宜居性、了解大气水循环以及估计从风化层中提取水以供原位资源利用 (ISRU) 的效率至关重要。本文介绍了利用 SpaceQ 设施模拟火星条件下近地表水循环的应用。好奇号火星车环境监测站 (REMS) 在盖尔陨石坑的观测结果表明,大气 HO 体积混合比 (VMR) 在夜间处于非平衡状态,大气含水量在数小时内下降了 15 g/m 。这种减少表明,地面在夜间可能作为冷阱清除大气中的水。在这里,我们使用实验方法研究了在接近饱和的环境中,大气、非多孔表面 (LN-冷却金属)、各种盐、火星模拟风化层以及盐和模拟风化层混合物之间的水交换的热力学和动力学。我们进行了三个实验:在实验 1 中研究了近三角点附近的纯液态水的稳定性,以及当表面饱和时观察到大气和盐之间的水交换;在实验 2 中,将盐与莫哈韦火星模拟物 (MMS) 混合,观察与水合物和液态卤水相互作用引起的风化层结构变化,并量化火星风化层吸收和保留水的潜力;实验 3 研究了当空气和地面温度相同且相对湿度接近饱和时,远离三相点温度的纯液态水蒸发的情况。我们通过实验表明,当达到饱和时,霜可以自发地在表面上形成,并且当温度高于 273.15 K (0 °C) 时,这种霜可以转化为液态水,在火星表面条件下可以持续 3.5 到 4.5 小时。相比之下,我们研究了在火星表面存在的某些潮解盐的行为,这些盐在几小时内可以通过吸收大气中的水分使质量增加 32% 到 85%。这些盐的混合物以 10%的浓度与模拟风化层混合,会产生具有约 18 到 50 重量%的水增益的聚合颗粒结构。模拟地面捕获了多达 53%的大气水,以液态水、水合物或卤水的形式存在。