Department of Agriculture and Fisheries, PO Box 102, Toowoomba, Queensland, 4350, Australia.
School of Chemical Engineering, University of Queensland, St Lucia, Queensland, Australia.
J Environ Manage. 2022 Feb 15;304:114264. doi: 10.1016/j.jenvman.2021.114264. Epub 2021 Dec 11.
Enhanced efficiency fertilisers (EEF) may reduce nitrogen (N) losses and improve uptake efficiency through synchronising N release with in-season plant requirements. We hypothesised that EEF formed via matrix encapsulation in biodegradable polymers will improve N use efficiency when compared to conventional urea fertiliser. This hypothesis was investigated for two biodegradable polymer matrices: polyhydroxyalkanoate (PHA), containing 11.6% urea (by mass), and polybutylene-adipate-co-terephthalate (PBAT), containing either 19.4 or 32.7% urea; and two contrasting soil types: sand and clay. Nitrogen availability and form was investigated under leaching conditions (water) with a growth accelerator pot experiment involving a horticultural crop and novel non-destructive three-dimensional scanning to measure in-season biomass development. The PBAT 32.7% formulation enabled greater above ground biomass production at both 50 and 100 kg N ha equivalent application rates compared to conventional urea. For the sandy soil, plant scanning indicated that improved uptake performance with PBAT 32.7% was probably the result of greater N availability after 25 days than for conventional urea. Two of the encapsulated formulations (PHA and PBAT 19.4%) tended to decrease nitrogen leaching losses relative to urea (P < 0.05 for the red clay soil). However, decreased N leaching loss was accompanied by poorer N uptake performance, indicative of N being less available in these biopolymer formulations. A snapshot of nitrous oxide emissions collected during peak nitrate concentration (prior to planting and leaching) suggested that the biopolymers promoted N loss via gaseous emission relative to urea in the sandy soil (P < 0.05), and carbon dioxide emissions data suggested that biopolymer-carbon increased microbial activity (P < 0.1). Controlled testing of N release in water was a poor predictor of biomass production and leaching losses. The diverse behaviours of the tested formulations present the potential to optimise biopolymers and their N loadings by taking into account soil and environmental factors that influence the efficient delivery of N to target crops. The greater N uptake efficiency demonstrated for the PBAT 32.7% formulation confirms our hypothesis that matrix encapsulation can enable better synchronisation of N release with crop requirements and decrease leaching losses.
增效肥料(EEF)可以通过使氮(N)释放与季节植物需求同步来减少氮损失并提高吸收效率。我们假设,通过生物降解聚合物的基质包封形成的 EEF 将比传统尿素肥料提高氮利用效率。本研究通过两种生物降解聚合物基质进行了验证:聚羟基烷酸酯(PHA),含有 11.6%(按质量计)的尿素;和聚丁二酸丁二醇酯-对苯二甲酸酯(PBAT),分别含有 19.4%或 32.7%的尿素;以及两种不同的土壤类型:沙土和粘土。在淋溶条件(水)下,通过生长促进剂盆栽实验调查了氮的有效性和形态,该实验涉及园艺作物和新型非破坏性三维扫描,以测量季节生物量的发育。与传统尿素相比,在 50 和 100 kg N ha 等效施用量下,PBAT 32.7%配方均能提高地上生物量的产生。对于沙土,植物扫描表明,与传统尿素相比,25 天后 PBAT 32.7%的吸收性能提高可能是由于氮的有效性更高。两种包封配方(PHA 和 PBAT 19.4%)与尿素相比,往往减少氮淋失损失(红粘土土壤中 P <0.05)。然而,氮淋失损失的减少伴随着氮吸收性能的下降,表明这些生物聚合物配方中的氮可用性较低。在硝酸盐浓度峰值(种植前和淋洗前)期间收集的氧化亚氮排放的快照表明,与沙土中的尿素相比,生物聚合物促进了氮通过气态排放的损失(P <0.05),并且二氧化碳排放数据表明生物聚合物-碳增加了微生物活性(P <0.1)。在水中控制氮释放的测试是生物量生产和淋失损失的不良预测因子。所测试配方的多样化行为有可能通过考虑影响氮向目标作物有效输送的土壤和环境因素来优化生物聚合物及其氮负荷。对于 PBAT 32.7%配方,我们观察到氮吸收效率的提高,这证实了我们的假设,即基质包封可以更好地使氮释放与作物需求同步,并减少淋失损失。