Four-Dimensional Computed Tomography-Guided Valve Sizing for Transcatheter Pulmonary Valve Replacement.

The measurements of the right ventricle (RV) and pulmonary artery (PA), for selecting the optimal prosthesis size for transcatheter pulmonary valve replacement (TPVR), vary considerably. Three-dimensional (3D) computed tomography (CT) imaging for device size prediction is insufficient to assess the displacement of the right ventricular outflow tract (RVOT) and PA, which could increase the risk of stent misplacement and paravalvular leak. The aim of this study is to provide a dynamic model to visualize and quantify the anatomy of the RVOT to PA over the entire cardiac cycle by four-dimensional (4D) cardiac CT reconstruction to obtain an accurate quantitative evaluation of the required valve size. In this pilot study, cardiac CT from sheep J was chosen to illustrate the procedures. 3D cardiac CT was imported into 3D reconstruction software to build a 4D sequence which was divided into eleven frames over the cardiac cycle to visualize the deformation of the heart. Diameter, cross-sectional area, and circumference of five imaging planes at the main PA, sinotubular junction, sinus, basal plane of the pulmonary valve (BPV), and RVOT were measured at each frame in 4D straightened models prior to valve implantation to predict the valve size. Meanwhile, dynamic changes in the RV volume were also measured to evaluate right ventricular ejection fraction (RVEF). 3D measurements at the end of the diastole were obtained for comparison with the 4D measurements. In sheep J, 4D CT measurements from the straightened model resulted in the same choice of valve size for TPVR (30 mm) as 3D measurements. The RVEF of sheep J from pre-CT was 62.1 %. In contrast with 3D CT, the straightened 4D reconstruction model not only enabled accurate prediction for valve size selection for TPVR but also provided an ideal virtual reality, thus presenting a promising method for TPVR and the innovation of TPVR devices.