Treatment of Polymeric Films Used for Printed Electronic Circuits Using Ambient Air DBD Non-Thermal Plasma.

This study aims to present the properties of the polymeric films after being subjected to DBD plasma treatment in atmospheric conditions. Three different commercial films of polyester (Xerox Inkjet transparencies and Autostat CUS5 Clear film) and polycarbonate (Lexan™ 8010 MC) have been considered for the tests. The surface wettability has been evaluated based on static water contact angle (WCA) for different treatment times varying between 0.2 s and 30 s, the results revealing a maximum WCA decrease compared to a pristine of up to 50% for Xerox films, 75% for Autostat and 70% for Lexan. The persistence of the hydrophilic effect induced by the plasma treatment has also been verified for up to 72 h of storage after treatment, the results indicating a degradation of the treatment effects starting with the first hours after the treatment. The WCA stabilizes to a value inferior to the one corresponding to pristine in the first 24 h after plasma treatment. The adhesion forces, as well as preliminary surface morphology evaluations have been determined for the considered films using atomic force microscopy (AFM). The adhesion forces are increased together with the prolongation of the plasma treatment application time, varying from initial values of 165 nN, 58 nN and 204 nN to around 390 nN, 160 nN and 375 nN for Xerox, Autostat and Lexan films, respectively, after 5 s of DBD treatment. For the considered materials, the results revealed that the plasma treatment determines morphological changes of the surfaces indicating an increase in surface roughness.