CICECO-Aveiro Institute of Materials, Department of Chemistry, University of Aveiro, 3810-193 Aveiro, Portugal.
Department of Biology, School of Science and Technology, University of Évora, 7006-554 Évora, Portugal.
Int J Mol Sci. 2022 Mar 10;23(6):2989. doi: 10.3390/ijms23062989.
Neonicotinoids are systemic insecticides commonly used for pest control in agriculture and veterinary applications. Due to their widespread use, neonicotinoid insecticides (neonics) are found in different environmental compartments, including water, soils, and biota, in which their high toxicity towards non-target organisms is a matter of great concern. Given their widespread use and high toxicity, the development of strategies to remove neonics, while avoiding further environmental contamination is of high priority. In this work, ionic-liquid-based materials, comprising silica modified with tetraalkylammonium cations and the chloride anion, were explored as alternative adsorbent materials to remove four neonics insecticides, namely imidacloprid, acetamiprid, thiacloprid, and thiamethoxam, from aqueous media. These materials or supported ionic liquids (SILs) were first synthesized and chemically characterized and further applied in adsorption studies. It was found that the equilibrium concentration of the adsorbate in the solid phase decreases with the decrease in the SIL cation alkyl chain length, reinforcing the relevance of hydrophobic interactions between ionic liquids (ILs) and insecticides. The best-identified SIL for the adsorption of the studied insecticides corresponds to silica modified with propyltrioctylammonium chloride ([Si][N3888]Cl). The saturation of SILs was reached in 5 min or less, showing their fast adsorption rate towards all insecticides, in contrast with activated carbon (benchmark) that requires 40 to 60 min. The best fitting of the experimental kinetic data was achieved with the Pseudo Second-Order model, meaning that the adsorption process is controlled at the solid-liquid interface. On the other hand, the best fitting of the experimental isotherm data is given by the Freundlich isotherm model, revealing that multiple layers of insecticides onto the SIL surface may occur. The continuous removal efficiency of the best SIL ([Si][N3888]Cl) by solid-phase extraction was finally appraised, with the maximum adsorption capacity decreasing in the following sequence: imidacloprid > thiacloprid > thiamethoxam > acetamiprid. Based on real reported values, under ideal conditions, 1 g of [Si][N3888]Cl is able to treat at least 106 m3 of wastewater and water from wetland contaminated with the studied neonics. In summary, the enhanced adsorption capacity of SILs for a broad diversity of neonics was demonstrated, reinforcing the usefulness of these materials for their removal from aqueous matrices and thus contributing to preventing their introduction into the ecosystems and reducing their detrimental effects in the environment and human health.
新烟碱类是一种常用于农业和兽医领域防治害虫的内吸性杀虫剂。由于其广泛使用,新烟碱类杀虫剂(新烟碱)存在于不同的环境介质中,包括水、土壤和生物群,其对非靶标生物的高毒性引起了极大关注。鉴于其广泛使用和高毒性,开发去除新烟碱的策略,同时避免进一步的环境污染至关重要。在这项工作中,我们探索了基于离子液体的材料,这些材料由用四烷基铵阳离子和氯离子改性的二氧化硅组成,作为替代吸附材料,用于从水介质中去除四种新烟碱类杀虫剂,分别是吡虫啉、噻虫胺、噻虫啉和噻虫嗪。这些材料或负载型离子液体(SILs)首先被合成并进行了化学表征,然后进一步应用于吸附研究。结果表明,吸附剂在固相中平衡浓度随 SIL 阳离子烷基链长度的降低而降低,这增强了离子液体(ILs)与杀虫剂之间的疏水相互作用的相关性。对于所研究的杀虫剂的吸附,识别出的最佳 SIL 对应于用丙基三辛基氯化铵改性的二氧化硅([Si][N3888]Cl)。SILs 的饱和在 5 分钟或更短时间内达到,表明它们对所有杀虫剂的吸附速率很快,而活性炭(基准)则需要 40 到 60 分钟。实验动力学数据的最佳拟合是由准二级模型获得的,这意味着吸附过程是在固液界面上控制的。另一方面,实验等温线数据的最佳拟合是由 Freundlich 等温线模型给出的,这表明可能在 SIL 表面上发生杀虫剂的多层吸附。最后评估了最佳 SIL([Si][N3888]Cl)通过固相萃取的连续去除效率,最大吸附容量按以下顺序降低:吡虫啉>噻虫啉>噻虫嗪>噻虫胺。根据实际报告的值,在理想条件下,1 克[Si][N3888]Cl 能够处理至少 106 立方米受研究新烟碱污染的废水和湿地水。总之,我们证明了 SILs 对广泛的新烟碱类的增强吸附能力,这增强了这些材料从水基质中去除新烟碱的有用性,从而有助于防止它们进入生态系统,并减少它们对环境和人类健康的有害影响。