Mohanty Shubhranshu S, Vasavda Akash N, Rai Abhishek K, Rathod Tushar N, Kamble Prashant, Keny Swapnil
Department of Orthopaedics, Seth Gordhandas Sunderdas Medical College (GSMC) and King Edward Memorial (KEM) Hospital, Mumbai, IND.
Cureus. 2022 Mar 17;14(3):e23257. doi: 10.7759/cureus.23257. eCollection 2022 Mar.
Introduction Mechanical loading continuously exposes the bone to remodeling processes. Increased load leads to a gain in bone mass, and reduced load results in a loss. After inserting a prosthesis, the proximal femur is bypassed in loading as the bodyweight shifts distally. This lack of load induces bone resorption according to Wolff's law. To avoid this bone resorption, the implant's bending stiffness should be less than the femoral bone. Dual-energy X-ray absorptiometry (DEXA) is a well-accepted method to measure periprosthetic bone mineral density (BMD) after total hip arthroplasty (THA). Since the strength and durability of the fixation of a femoral prosthesis in cementless hip arthroplasty depend largely on the quantity and quality of the surrounding bone, preoperative and postoperative evaluation of the quantity and quality of the femoral bone is very important in the long-term prognosis of hip arthroplasty. Materials and methods A prospective study of 110 patients in the age group of 25-60 years who underwent uncemented total hip arthroplasty in our tertiary healthcare institution was performed. An uncemented, fully hydroxyapatite-coated implant from a single manufacturer was used in all the patients. All the patients were mobilized on the first post-operative day. The BMD was measured at the proximal femur and the distal tip using a DEXA scan. Gruen zones were used for calculating BMD at different anatomical locations in the femur, with particular importance to zones 1, 4, and 7. Results The pre-operative BMD in all zones measured, viz. zones 1, 4, and zone 7 of the affected side, was found to be significantly lower as compared to the BMD values on the control side (P< 0.05). The mean change in the mean BMD was calculated for all the zones and compared with each other using an unpaired t-test. The mean BMD changes were found to be significantly higher in zone 7 in comparison to both zones 1 and 4 (p<0.05). Conclusion Significant periprosthetic bone loss after uncemented THA in the femur was noted in Gruen zones 1, 4, and 7 during the first six months after THA, with the greatest bone loss in the femoral calcar area (zone 7). The lower the preoperative BMD of the patient, the greater the postoperative bone loss.
引言 机械负荷使骨骼持续经历重塑过程。负荷增加会导致骨量增加,负荷减少则会导致骨量流失。植入假体后,由于体重向远端转移,股骨近端在负荷传递中被绕过。根据沃尔夫定律,这种负荷缺失会引发骨质吸收。为避免这种骨质吸收,植入物的弯曲刚度应小于股骨。双能X线吸收法(DEXA)是全髋关节置换术(THA)后测量假体周围骨密度(BMD)的一种广泛认可的方法。由于非骨水泥型髋关节置换术中股骨假体固定的强度和耐久性在很大程度上取决于周围骨骼的数量和质量,因此术前和术后评估股骨的数量和质量对髋关节置换术的长期预后非常重要。
材料与方法 对在我们三级医疗机构接受非骨水泥型全髋关节置换术的110名年龄在25至60岁之间的患者进行了一项前瞻性研究。所有患者均使用了来自单一制造商的非骨水泥型、完全羟基磷灰石涂层的植入物。所有患者在术后第一天即可活动。使用DEXA扫描在股骨近端和远端测量骨密度。Gruen分区用于计算股骨不同解剖位置的骨密度,其中第1、4和7区尤为重要。
结果 所有测量区域,即患侧的第1、4区和第7区,术前骨密度均显著低于对照侧的骨密度值(P<0.05)。计算所有区域的平均骨密度平均变化,并使用非配对t检验进行相互比较。发现第7区的平均骨密度变化显著高于第1区和第4区(p<0.05)。
结论 在THA后的前六个月,在Gruen第1、4和7区观察到非骨水泥型THA后股骨假体周围出现显著的骨质流失,股骨距区域(第7区)骨质流失最为严重。患者术前骨密度越低,术后骨质流失越大。