Nguyen Huynh Ngoc Minh, Boeva Zhanna A, Smått Jan-Henrik, Pesonen Markus, Lindfors Tom
Åbo Akademi University, Faculty of Science and Engineering, Laboratory of Analytical Chemistry, (Johan Gadolin Process Chemistry Centre, PCC) 20500 Åbo Finland
Åbo Akademi University, Faculty of Science and Engineering, Laboratory of Physical Chemistry (Center for Functional Materials, FUNMAT) 20500 Åbo Finland.
RSC Adv. 2018 May 15;8(32):17645-17655. doi: 10.1039/c8ra03080d. eCollection 2018 May 14.
Herein, we report the incorporation of a 10 μm thick reduced graphene oxide (RGO) barrier layer in a plasticized poly(vinyl chloride) (PVC) film as the main constituent in ion-selective membranes used in potentiometric solid-contact ion-selective electrodes (SCISE). Fourier transform infrared attenuated total reflection (FTIR-ATR) and oxygen transmission rate (OTR) measurements showed that the embedded RGO barrier efficiently impedes the diffusion of liquid water, carbon dioxide and oxygen (O) through the 400 μm thick PVC film, which causes potential instability and irreproducibility of the SCISEs. The measurements revealed that the RGO layer completely blocks the carbon dioxide diffusion, while it fully blocks the water diffusion for 16 h and reduced the OTR by 85% on average. The μm-thick RGO films used in this study were easier to handle and incorporate into host polymers, and form more efficient and robust barriers compared to the mono-, few- and multilayer graphene commonly applied as barrier layers for liquids and gases. We also demonstrated that the FTIR-ATR technique employed in the permeability measurements is a versatile and very sensitive technique for studying the diffusion of small amounts of water and carbon dioxide through graphene-based thin films.
在此,我们报告了在增塑聚氯乙烯(PVC)薄膜中加入10μm厚的还原氧化石墨烯(RGO)阻挡层,作为电位型固体接触离子选择电极(SCISE)中离子选择膜的主要成分。傅里叶变换红外衰减全反射(FTIR-ATR)和透氧率(OTR)测量表明,嵌入的RGO阻挡层有效地阻碍了液态水、二氧化碳和氧气(O)通过400μm厚的PVC薄膜的扩散,而这会导致SCISE的电位不稳定和不可重复性。测量结果显示,RGO层完全阻止了二氧化碳的扩散,同时在16小时内完全阻止了水的扩散,平均使OTR降低了85%。本研究中使用的μm厚RGO薄膜比通常用作液体和气体阻挡层的单层、少层和多层石墨烯更易于处理和掺入主体聚合物中,并且能形成更高效、更坚固的阻挡层。我们还证明,渗透率测量中使用的FTIR-ATR技术是一种用于研究少量水和二氧化碳通过石墨烯基薄膜扩散的通用且非常灵敏的技术。