Parallel perturbation analysis of combustion cycle-to-cycle variations and emissions characteristics in a natural gas spark ignition engine with comparison to consecutive cycle method.

Severe combustion cycle-to-cycle variations (CCVs) in spark ignition (SI) engines significantly increase partial or incomplete combustion cycles, which may result in combustion instability or even misfire under extreme conditions, thereby seriously affecting the engine performance and increasing the unburned hydrocarbon and carbon monoxide emissions. In this study, the consecutive cycle method (CCM) and parallel perturbation method (PPM) are utilized to simulate the CCVs in a natural-gas (NG) SI engine. Specifically, 25 consecutive and concurrent cycles of the SI engine are simulated, and simulation results are compared with the experimental data. Further, the factors affecting the CCVs and exhaust emissions in the NG SI engine are verified by analyzing the low-pressure (LP) and high-pressure (HP) cycles. The results indicate that the simulated in-cylinder pressures of the NG SI engine based on PPM are basically in agreement with the experimental in-cylinder pressure distribution range, which suggests that the PPM can effectively predict the CCVs in NG SI engines. Furthermore, the required wall clock time for the simulation of CCVs is greatly reduced from 1 to 2 months (using CCM) to 2-3 days by using the PPM, which makes it particularly suitable for the industrial applications. Besides, the velocity field of the HP cycle is obviously stronger than that of the LP cycle. During the early stage of flame development, the flame area and volume of LP and HP cycles do not show much difference. However, the flame front surface-volume ratio of the HP cycle is larger than that of the LP cycle at 15 CA after the spark timing. Furthermore, the emissions formation and oxidation of the NG SI engine are strongly depended on the HP and LP cycles due to the combustion rate and flame propagation in the cylinder.