Department of Chemistry, Merkert Chemistry Center, Boston College, Chestnut Hill, Massachusetts 02467, United States.
Supramolecular Science and Engineering Institute, University of Strasbourg, CNRS, 67000 Strasbourg, France.
J Am Chem Soc. 2023 Feb 15;145(6):3748-3762. doi: 10.1021/jacs.2c13245. Epub 2023 Jan 31.
Catalytic cross-metathesis (CM) reactions that can generate trisubstituted alkenes in high stereoisomeric purity are important but remain limited in scope. Here, CM reactions are introduced that generate -trisubstituted α-methyl, α,β-unsaturated, alkyl and aryl esters, thiol esters, and acid fluorides. Transformations are promoted by a Mo bis-aryloxide, a monoaryloxide pyrrolide, or a monoaryloxide chloride complex; air-stable and commercially available paraffin tablets containing a Mo complex may also be used. Alkyl, aryl, and silyl carboxylic esters as well as thiol esters and acid fluoride reagents are either purchasable or can be prepared in one step. Products were obtained in 55-95% yield and in 88:12->98:2 / ratio (typically >95:5). The applicability of the approach is highlighted by a two-step conversion of citronellol to an isomintlactone precursor (1.7 g, 73% yield, and 97:3 /) and a single-step transformation of lanosterol acetate to 3--anwuweizic acid (72% yield and 94:6 /). Included are the outcomes of DFT studies, regarding several initially puzzling catalyst activity trends, providing the following information: (1) it is key that a disubstituted Mo alkylidene, generated by a competing homo-metathesis (HM) pathway, can re-enter the productive CM cycle. (2) Whereas in a CM cycle the formation of a molybdacyclobutane is likely turnover-limiting, the collapse of related metallacycles in a HM cycle is probably rate-determining. It is therefore the relative energy barrier required for these steps that determines whether CM or HM is dominant with a particular complex.
催化交叉复分解(CM)反应能够以高立体异构体纯度生成三取代烯烃,这很重要,但适用范围仍然有限。在此,我们引入了生成 -三取代α-甲基、α,β-不饱和、烷基和芳基酯、硫酯和酸氟化物的 CM 反应。这些转化由 Mo 双芳氧基、单芳氧基吡咯烷或单芳氧基氯化物配合物促进;也可以使用空气稳定且市售的含有 Mo 配合物的石蜡片剂。烷基、芳基和硅烷基羧酸酯以及硫酯和酸氟化物试剂可以购买或一步制备。产物的收率为 55-95%,非对映异构体比例为 88:12->98:2/(通常>95:5)。该方法的适用性通过两步将橙花醇转化为异薄荷内酯前体(1.7g,73%收率,非对映异构体比例为 97:3/)和一步将羊毛甾醇乙酸酯转化为 3--阿魏酸(72%收率,非对映异构体比例为 94:6/)得到了突出体现。包括 DFT 研究的结果,涉及几个最初令人费解的催化剂活性趋势,提供了以下信息:(1)由竞争同型复分解(HM)途径生成的取代 Mo 亚烷基重新进入产率 CM 循环是关键。(2)虽然在 CM 循环中形成的钼杂环丁烷可能是周转率限制的,但在 HM 循环中相关金属环的崩塌可能是速率决定的。因此,决定 CM 或 HM 占主导地位的是特定配合物中这些步骤所需的相对能垒。