Kinesiology Laboratory, Geneva University Hospitals and University of Geneva, Geneva, Switzerland.
School of Health Sciences, University of Applied Sciences and Arts Western Switzerland (HES-SO), Geneva, Switzerland.
PLoS One. 2023 Mar 6;18(3):e0282517. doi: 10.1371/journal.pone.0282517. eCollection 2023.
Recovery of function is among a patient's main expectations when undergoing total knee arthroplasty (TKA). However, normal gait knee function is not always completely restored, which can affect patient satisfaction and quality of life. Computer-assisted surgery (CAS) allows surgeons to evaluate passive knee kinematics intra-operatively. Understanding associations between knee kinematics measured during surgery and during daily activities, such as walking, could help define criteria for success based on knee function and not only on the correct alignment of the implant or the leg. This preliminary study compared passive knee kinematics measured during surgery with active kinematics measured during walking. Eight patients underwent a treadmill gait analysis using the KneeKG™ system both before surgery and three months afterwards. Knee kinematics were measured during CAS both before and after TKA implantation. The anatomical axes of the KneeKG™ and CAS systems were homogenised using a two-level, multi-body kinematics optimisation with a kinematic chain based on the calibration measured during CAS. A Bland-Altman analysis was performed before and after TKA for adduction-abduction angle, internal-external rotation, and anterior-posterior displacement over the whole gait cycle, at the single stance phase and at the swing phase. Homogenising the anatomical axes between CAS and treadmill gait led to limited median bias and limits of agreement (post-surgery -0.6 ± 3.6 deg, -2.7 ± 3.6 deg, and -0.2 ± 2.4 mm for adduction-abduction, internal-external rotation and anterior-posterior displacement, respectively). At the individual level, correlations between the two systems were mostly weak (R2 < 0.3) over the whole gait cycle, indicating low kinematic consistency between the two measurements. However, correlations were better at the phase level, especially the swing phase. The multiple sources of differences did not enable us to conclude whether they came from anatomical and biomechanical differences or from measurement system errors.
膝关节置换术后患者的主要期望之一是恢复功能。然而,膝关节的正常步态功能并不总是完全恢复,这可能会影响患者的满意度和生活质量。计算机辅助手术(CAS)允许外科医生在术中评估膝关节的被动运动学。了解术中测量的膝关节运动学与日常活动(如行走)之间的关联,有助于根据膝关节功能而不仅仅是植入物或腿部的正确对准来定义成功标准。本初步研究比较了手术中测量的膝关节被动运动学与行走时测量的主动运动学。8 名患者在手术前和术后三个月使用 KneeKG™系统进行了跑步机步态分析。在 TKA 植入前后,通过 CAS 测量了膝关节运动学。使用基于 CAS 期间测量的校准的两级、多体运动学优化,使 KneeKG™和 CAS 系统的解剖轴同质化。在 TKA 前后对内外收角、内外旋转和整个步态周期、单足支撑期和摆动期的前后位移进行了 Bland-Altman 分析。在 CAS 和跑步机步态之间同质化解剖轴导致中位偏差和一致性界限有限(术后分别为 -0.6 ± 3.6 度、-2.7 ± 3.6 度和 -0.2 ± 2.4 毫米)。在个体水平上,两个系统之间的相关性大多较弱(R2 < 0.3),表明两个测量之间的运动学一致性较低。然而,在相位水平上相关性更好,尤其是摆动相位。多种差异来源无法确定它们是来自解剖学和生物力学差异还是来自测量系统误差。