Mandal A B, Ramesh D V, Dhar S C
Chemical and FT-NMR Laboratory, Central Leather Research Institute, Adyar, Madras, India.
Eur J Biochem. 1987 Dec 15;169(3):617-28. doi: 10.1111/j.1432-1033.1987.tb13653.x.
Sepia cartilage collagen (pepsin-extracted) in acetate buffer (pH = 2.98) forms micelles at a particular concentration below which they do not normally form. The critical micelle concentration (cmc) of the collagen was determined in buffer as well as in SDS, cetyltrimethylammonium bromide (CTAB) and Tween-80 micellar environments at different temperatures. Mutual interaction of collagen micelles with the ionic and nonionic micelles through the formation of the mixed micelle concept has also been found. The cmc of collagen decreased in the presence of SDS and Tween-80 micelles whereas it increased in the presence of CTAB micelles. This clearly suggests that the micelle formation of collagen is facilitated by the presence of SDS and Tween-80 and hindered by CTAB micelles. The various thermodynamic parameters were estimated from viscosity measurements and the transfer of collagen into the micelles of various surfactants and the reverse phenomenon was analyzed. This analysis has also been modelled conceptually as a different phase and the results have supported the above phenomenon. Our thermodynamic results are also able to predict the exact denaturation temperature as well as the structural order of water in the collagen in various environments. The hydrated volumes, Vh, of collagen in the above environments and intrinsic viscosity were also calculated. The low intrinsic viscosity, [eta], of collagen in an SDS environment compared to buffer and other surfactant environments suggested more workable systems in cosmetic and dermatological skin care preparations. The one and two-hydrogen-bonded models of this collagen in various environments have been analyzed. The calculated thermodynamic parameters varied with the concentration of collagen. The change of thermodynamic parameters from coil-coil to random-coil conformation upon denaturation of collagen were calculated from the amount of proline and hydroxyproline residues and compared with viscometric results. Thermodynamic results suggest that the stability of the collagen in the additive environments is in the following order: SDS greater than Tween-80 greater than buffer greater than CTAB.
乌贼软骨胶原蛋白(经胃蛋白酶提取)在乙酸盐缓冲液(pH = 2.98)中,在特定浓度下会形成胶束,低于该浓度通常不会形成。在不同温度下,测定了胶原蛋白在缓冲液以及十二烷基硫酸钠(SDS)、十六烷基三甲基溴化铵(CTAB)和吐温80胶束环境中的临界胶束浓度(cmc)。还发现胶原蛋白胶束通过形成混合胶束概念与离子型和非离子型胶束相互作用。在SDS和吐温80胶束存在下,胶原蛋白的cmc降低,而在CTAB胶束存在下则升高。这清楚地表明,SDS和吐温80的存在促进了胶原蛋白的胶束形成,而CTAB胶束则起到阻碍作用。通过粘度测量估算了各种热力学参数,并分析了胶原蛋白向各种表面活性剂胶束中的转移以及相反现象。这种分析在概念上也被建模为不同的相,结果支持了上述现象。我们的热力学结果还能够预测在各种环境中胶原蛋白的确切变性温度以及其中水的结构顺序。还计算了上述环境中胶原蛋白的水合体积Vh和特性粘度。与缓冲液和其他表面活性剂环境相比,胶原蛋白在SDS环境中的低特性粘度[η]表明其在化妆品和皮肤护理制剂中更具可行性。分析了这种胶原蛋白在各种环境中的单氢键和双氢键模型。计算得到的热力学参数随胶原蛋白浓度而变化。根据脯氨酸和羟脯氨酸残基的数量计算了胶原蛋白变性时从卷曲-卷曲构象到无规卷曲构象的热力学参数变化,并与粘度测量结果进行了比较。热力学结果表明,在添加剂环境中胶原蛋白的稳定性顺序为:SDS>吐温80>缓冲液>CTAB。