Copper-Based Nanomaterials for Fine-Pitch Interconnects in Microelectronics.

ConspectusNanostructured copper-based materials have emerged as a new generation of robust architectures for realizing high-performing and reliable interconnection in modern electronic packaging. As opposed to traditional interconnects, nanostructured materials offer better compliance during the packaging assembly process. Due to the high surface area-to-volume ratio of nanomaterials, they also enable joint formation by sintering through thermal compression at much lower temperatures compared to bulk counterparts. Nanoporous Cu (np-Cu) films have been employed in electronic packaging as materials that facilitate a chip-to-substrate interconnection, realized by a Cu-on-Cu bonding after sintering.In this Account, we discuss the use of self-supported np-Cu films for low-temperature joint formation. The novelty of this work comes from the incorporation of tin (Sn) into the np-Cu structure, thus ensuring lower sintering temperatures with a goal of producing Cu-Sn intermetallic alloy-based joints between two Cu substrates. The incorporation of Sn is done using an all-electrochemical bottom-up approach that involves the conformal coating of fine-structured np-Cu (initially formed by dealloying of Cu-Zn alloys) with a thin layer of Sn.This Account provides insight on existing technologies for using nanostructured films as materials for interconnects as well as the optimization studies for the Sn-coating processes as a new alternative approach. The applicability of the synthesized Cu-Sn nanomaterials for low-temperature joint formation is also discussed. To realize this new approach, the Sn-coating process is administered by a galvanic pulse plating technique, which is optimized to preserve the porosity in the structure with a Cu/Sn atomic ratio that allows for the formation of the CuSn intermetallic compound (IMC). Nanomaterials obtained using this approach are subjected to joint formation by sintering at temperatures between 300 and 200 °C under 20 MPa pressure in forming gas atmosphere. Cross-section characterization of the formed joints postsintering reveals densified bonds with minimal porosity that consist predominantly of the CuSn IMC. Furthermore, these joints are less prone to structural inconsistencies compared to existing joints formed using purely np-Cu. The results presented in this Account provide a glimpse into a facile and cost-effective approach for synthesizing nanostructured Cu-Sn films and illustrate their applicability as new interconnect materials.