Suppr超能文献

可视环锯法在经皮内镜腰椎间融合术中导致手术节段和临近节段的不对称性的应力改变和不稳定性:有限元分析。

Visible trephine-based foraminoplasty in PTED leads to asymmetrical stress changes and instability in the surgical and adjacent segments: a finite element analysis.

机构信息

Department of Spine Surgery, Qilu Hospital of Shandong University, Wenhuaxi Road No.107, Jinan, 250012, People's Republic of China.

Department of Physician Training, Qilu Hospital of Shandong University, Jinan, People's Republic of China.

出版信息

J Orthop Surg Res. 2023 Jun 13;18(1):431. doi: 10.1186/s13018-023-03916-0.

Abstract

This study aimed to construct a multi-segment lumbar finite element model (FEM) of PTED surgery to analyze the changes in stress and ROM after visible trephine-based foraminoplasty. The CT scans of a 35-year-old healthy male were used to develop a multi-segment lumbar FEM with Mimic, Geomagic Studio, Hypermesh and MSC.Patran. Different foraminoplasty was performed on the model, and these were grouped into normal group (A), the ventral resection group (B), the apex resection group (C), the ventral + apex + isthmus resection group (D), and the SAP + isthmus + lateral recess resection group (E). A vertical load of 500N and a torque of 10N·M were applied to the upper surface of the L3 vertebral body to simulate the biomechanical characteristics under the motion of flexion, extension, lateral bending, and rotation. The von Mises stress maps of the intervertebral f, vertebral body, facet joints, and the ROM of the L3-S1 intervertebral disk were calculated and analyzed. The changes of peak stress on the vertebral body for each group were not significant in the same motion state. Significant stress differences were observed in the L4/5 intervertebral disks, while no obvious stress changes were observed for the L3/4 and L5/S1 intervertebral disks. The stress of the L3/4 and L5/S1 facet joints decreased after L4/5 foraminoplasty, while the stress of L4/5 facet joints displayed an overall increasing trend. Significant asymmetrical stress changes of bilateral facet joints were observed in all three segments, particularly during bilateral rotation movements. The ROM of L3-S1 gradually increased from Group A to Group E, especially during flexion, left lateral bending, and right rotation, with the highest elevation observed for the L45 ROM. Our FEM indicated that enlarged resection and exposure of the articular surface could lead to significant asymmetrical stress changes in the bilateral facet joints and ROM instability of the surgical and adjacent segments. These findings suggested that unnecessary and excessive resection should be avoided in PTED to reduce the incidence of low back pain and the risk of postsurgical degeneration.

摘要

本研究旨在构建基于经皮椎间孔内镜手术(PTED)的多节段腰椎有限元模型(FEM),以分析可视环锯下椎间孔成形术后的应力和 ROM 变化。使用一名 35 岁健康男性的 CT 扫描来开发多节段腰椎 FEM,采用 Mimic、Geomagic Studio、Hypermesh 和 MSC.Patran。在模型上进行不同的椎间孔成形术,将其分为正常组(A)、腹侧切除组(B)、尖部切除组(C)、腹侧+尖部+峡部切除组(D)和 SAP+峡部+侧隐窝切除组(E)。在 L3 椎体的上表面施加 500N 的垂直载荷和 10N·M 的扭矩,以模拟屈伸、侧屈和旋转运动下的生物力学特性。计算并分析了椎间 f、椎体、关节突关节的 von Mises 等效应力图以及 L3-S1 椎间盘的 ROM。在同一运动状态下,各实验组椎体的峰值应力变化不显著。在 L4/5 椎间盘观察到明显的应力差异,而在 L3/4 和 L5/S1 椎间盘则未见明显的应力变化。L4/5 椎间孔成形术后,L3/4 和 L5/S1 关节突关节的应力减小,而 L4/5 关节突关节的应力呈整体增加趋势。在所有三个节段,双侧关节突关节均观察到明显的不对称性应力变化,特别是在双侧旋转运动时。L3-S1 的 ROM 从 A 组到 E 组逐渐增加,特别是在屈伸、左测弯和右旋转时,L45 ROM 升高最为明显。我们的 FEM 表明,关节面的扩大切除和暴露会导致双侧关节突关节的显著不对称性应力变化以及手术和相邻节段的 ROM 不稳定。这些发现表明,在 PTED 中应避免不必要和过度的切除,以降低腰痛的发生率和术后退变的风险。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/34bd/10265803/168ff4982942/13018_2023_3916_Fig1_HTML.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验