Soppie Anny Geraldo, Betené Achille Desire Omgba, Anicet Noah Pierre Marcel, Njom Abel Emmanuel, Betené Ebanda Fabien, Ateba Atangana, Mewoli Armel, Efeze Didimus Nkemaja, Moukené Roger
Laboratory of Mechanics, Doctoral Training Unit in Engineering Sciences (UFD-SI), University of Douala, P.O. Box: 1872, Douala, Cameroon.
Department of Textiles and Clothing Industry, ENSET, University of Douala, P.O. Box: 1872, Douala, Cameroon.
Heliyon. 2023 Jun 23;9(6):e17581. doi: 10.1016/j.heliyon.2023.e17581. eCollection 2023 Jun.
Tropical (TC) fibre extracted from the equatorial region of Cameroon has been characterized as a potential fibre for textiles. An investigation of extraction parameters to soften this fibre is crucial to use it as a biobased material in the spinning process. To obtain textile quality fibres, 34 sodium hydroxide extraction tests were carried out to study the effect of extraction conditions on its characteristics. Thus, three levels of concentrations (0.5, 1.0 and 1.5 wt%), temperatures (80, 100 and 120 °C) and durations (120, 180 and 240min) were used for extraction by cooking, and at room temperature, durations of 120, 150 or 180 min with three concentrations (2.5, 3.0 and 3.5 wt%) were considered. Only 6 combinations produced fibres that were clear and soft to the touch, without defects (corrugations, stuck fibres) and without residual bark epidermis at the macroscopic scale. For these fibres, the dissolution of non-cellulosic substances, morphological, physical, thermal and mechanical properties depended on the austerity of the alkaline retting. Under mild conditions, the SEM surfaces of the fibres showed large residues of the middle lamella, which made the lignin content (10 wt%) and hydrophilic function higher. Under medium conditions, the fibre surfaces were clean and slightly wrinkled (at 80 °C; 120min). Under severe conditions, heterogeneous transverse shrinkage and wrinkling were observed and accompanied by cellulose degradation (39 wt%) with a significant reduction in tenacity at 16cN/tex. The medium extraction conditions were considered more effective, and their fibres showed cellulose content up to 49 wt%, density up to 1.39 g cm, "Fickian" moisture absorption kinetics with saturation up to 11 wt%, thermal stability up to 237 °C, Young's modulus up to 3.7 GPa, tensile strength up to 113 MPa and tenacity up to 40cN/tex. These new results were compared with lignocellulosic textile fibres in the literature, showing similarity with banana, sisal and jute fibres.
从喀麦隆赤道地区提取的热带(TC)纤维已被认定为一种潜在的纺织纤维。研究提取参数以软化这种纤维对于在纺纱过程中将其用作生物基材料至关重要。为了获得具有纺织品质的纤维,进行了34次氢氧化钠提取试验,以研究提取条件对其特性的影响。因此,采用了三种浓度水平(0.5、1.0和1.5重量%)、温度(80、100和120°C)和持续时间(120、180和240分钟)通过蒸煮进行提取,并且在室温下,考虑了三种浓度(2.5、3.0和3.5重量%)下120、150或180分钟的持续时间。只有6种组合产生的纤维在宏观尺度上清晰且手感柔软,没有缺陷(皱纹、粘连纤维)且没有残留的树皮表皮。对于这些纤维,非纤维素物质的溶解、形态、物理、热和机械性能取决于碱性脱胶的程度。在温和条件下,纤维的扫描电子显微镜表面显示出大量中层薄片的残留物,这使得木质素含量(10重量%)和亲水功能更高。在中等条件下,纤维表面干净且略有皱纹(在80°C;120分钟)。在苛刻条件下,观察到不均匀的横向收缩和起皱,并伴随着纤维素降解(39重量%),在16厘牛/特克斯时强度显著降低。中等提取条件被认为更有效,其纤维的纤维素含量高达49重量%,密度高达1.39克/立方厘米,“菲克”吸湿动力学,饱和度高达11重量%,热稳定性高达237°C,杨氏模量高达3.7吉帕,拉伸强度高达113兆帕,强度高达40厘牛/特克斯。这些新结果与文献中的木质纤维素纺织纤维进行了比较,显示出与香蕉、剑麻和黄麻纤维的相似性。