Zwart A, Luijendijk S C, de Vries W R
Pflugers Arch. 1986 Aug;407(2):211-5. doi: 10.1007/BF00580678.
The steady state gas transfer properties of the lung can be derived from excretion-retention (E-R) data of inert tracer gases that are infused intravenously. E = PE/Pv and R = Pa/Pv, where PE, Pa and Pv represent the partial pressures of the tracer gases in mixed expired gas, arterial blood and mixed venous blood, respectively. In this paper, we investigate the influence of diffusive gas mixing in the lung on E and R. To that end, E-R data sets were simulated with a lung model that takes into account tidal breathing, the morphometric geometry of the airways, diffusion limited gas mixing in the alveolar space and gas dissolved in superficial lung tissue. The results show a linear relationship between R/E and D-0.5, where D represents the diffusion coefficient of the tracer gases in the alveolar gas mixture. This is in contrast to the results of simulations with a lung model that describes the different gas transport mechanisms, including diffusion, as a constant rate process, where a linear relationship between R/E and D-1 is predicted. It is further shown that E-R data of helium and sulphur hexafluoride cannot be used to demonstrate diffusion limited gas mixing in the lung, in particular, in the presence of a real shunt fraction. For that purpose, excretion data of pairs of tracer gases with different D but equal, medium blood-gas partition coefficients (1 less than lambda less than 30) should be used. For such pairs of tracer gases, the E values may differ by more than 10% when the D values for the two gases are 0.22 and 0.1 cm2s-1, respectively.(ABSTRACT TRUNCATED AT 250 WORDS)
肺的稳态气体传输特性可从静脉注射惰性示踪气体的排泄-潴留(E-R)数据推导得出。E = PE/Pv且R = Pa/Pv,其中PE、Pa和Pv分别代表呼出混合气体、动脉血和混合静脉血中示踪气体的分压。在本文中,我们研究了肺内扩散性气体混合对E和R的影响。为此,使用一个肺模型模拟E-R数据集,该模型考虑了潮气呼吸、气道的形态计量学几何结构、肺泡空间中扩散受限的气体混合以及肺表层组织中溶解的气体。结果显示R/E与D-0.5之间存在线性关系,其中D代表示踪气体在肺泡气体混合物中的扩散系数。这与一个将包括扩散在内的不同气体传输机制描述为恒定速率过程的肺模型模拟结果形成对比,该模型预测R/E与D-1之间存在线性关系。进一步表明,氦气和六氟化硫的E-R数据不能用于证明肺内扩散受限的气体混合,特别是在存在实际分流分数的情况下。为此,应使用具有不同D但中等血气分配系数相等(1<λ<30)的成对示踪气体的排泄数据。对于这样的成对示踪气体,当两种气体的D值分别为0.22和0.1 cm2s-1时,E值可能相差超过10%。(摘要截取自250字)