Department of Urology, University Medical Center Utrecht, Utrecht, The Netherlands.
Mathematics of Multiscale Modeling and Simulation, Department of Applied Mathematics, University of Twente, Enschede, The Netherlands.
Neurourol Urodyn. 2023 Nov;42(8):1628-1638. doi: 10.1002/nau.25270. Epub 2023 Aug 23.
A pressure flow study (PFS), part of the International Continence Society standard urodynamic test, is regarded gold standard for the classification and quantification of the urethral resistance (UR), expressed in the bladder outflow obstruction (BOO). For men with benign prostatic hyperplasia, the minimum urethral opening pressure (p ), found at the end of the passive urethral resistance relation is considered the relevant parameter describing BOO. However, in clinical practice, direct measurements of p are easily confounded by terminal dribbling. For that reason, alternative methods were developed to derive p , and thereby assess BOO using the maximum urine flow rate (Q ) and the corresponding pressure (p ) instead. These methods were never directly compared against a large data set. With the increasing variety of treatments becoming available more precise grading of UR may become of relevance. The current study compares four well-known methods to approximate p and examines the relation between p and p .
In total, 1717 high-quality PFS of men referred with lower urinary tract symptoms between 2003 and 2020 without earlier lower urinary tract surgery were included. From these recordings, p was calculated according to three one-parameter methods. In addition, a three-parameter method (3PM) was used, based on a fit through the lowest pressure flank of the pressure-flow plot. The estimated p 's were compared with a precisely assessed p . A difference of <10 cmH O between an estimate and the actual p was considered accurate. A comparison between the four approximation methods and the actual p was visualized using a Bland-Altman plot. The differences between the actual and the estimated slope were assessed and dependency on p was analyzed.
A total of 1717 studies were analyzed. In 55 (3.2%) PFS, 3PM analysis was impossible because all pressures after Q were higher than p . The 3PM model was superior in predicting p , with 75.9% of the approximations within a range of +10 or -10 cmH O of the actual p . Moreover, p according to urethral resistance A (URA) and linearized passive urethral resistance relation (linPURR) appear equally reliable. Bladder outflow obstruction index (BOOI) was significantly less accurate when compared to all others. Bland-Altman analysis showed a tendency of BOOI to overestimate p in men with higher grades of UR, while URA tended to underestimate p in those cases. The slope between p and p -Q increased with larger p , as opposed to the constant relation proposed within BOOI. Although significant differences were found, the clinical relevance of those differences is not known.
Of the four methods to estimate p and quantify BOO, 3PM was found the most accurate and BOOI the least accurate. As 3PM is not generally available and performance in lower quality PFS is unknown, linPURR is (for now) the most physiologically accurate.
压力流研究(PFS)是国际尿控协会标准尿动力学测试的一部分,被认为是尿道阻力(UR)分类和定量的金标准,以膀胱流出梗阻(BOO)表示。对于患有良性前列腺增生的男性,在被动尿道阻力关系结束时发现的最小尿道开口压力(p)被认为是描述 BOO 的相关参数。然而,在临床实践中,直接测量 p 容易受到终端滴漏的影响。因此,开发了替代方法来推导出 p ,并使用最大尿流率(Q)和相应的压力(p)来评估 BOO。这些方法从未直接与大型数据集进行比较。随着可供选择的治疗方法越来越多,UR 的更精确分级可能变得更加重要。本研究比较了四种著名的方法来近似 p ,并检查了 p 与 p 之间的关系。
共纳入 2003 年至 2020 年间因下尿路症状就诊且无早期下尿路手术史的 1717 例男性高质量 PFS。从这些记录中,根据三种单参数方法计算 p 。此外,还使用了一种基于压力流图最低压力侧翼拟合的三参数方法(3PM)。估计的 p '与精确评估的 p 进行比较。当估计值与实际 p 的差值<10cmH 2 O 时,认为是准确的。使用 Bland-Altman 图可视化四种近似方法与实际 p 之间的比较。评估实际和估计斜率之间的差异,并分析其与 p 的依赖性。
共分析了 1717 项研究。在 55 项(3.2%)PFS 中,由于 Q 之后的所有压力均高于 p ,因此无法进行 3PM 分析。3PM 模型在预测 p 方面表现更优,75.9%的估计值在实际 p 的+10 或-10cmH 2 O 范围内。此外,根据尿道阻力 A(URA)和线性化被动尿道阻力关系(linPURR)计算的 p 同样可靠。与其他所有方法相比,膀胱流出梗阻指数(BOOI)明显不准确。Bland-Altman 分析显示,BOOI 倾向于高估 UR 等级较高的男性的 p ,而 URA 则倾向于低估这些情况下的 p 。随着 p 的增加,p 与 p -Q 之间的斜率增加,而 BOOI 中提出的斜率是恒定的。尽管存在显著差异,但尚不清楚这些差异的临床意义。
在估计 p 和定量 BOO 的四种方法中,3PM 被认为是最准确的,而 BOOI 是最不准确的。由于 3PM 并非普遍可用,且其在低质量 PFS 中的性能尚不清楚,因此 linPURR 是目前最符合生理的方法。