Lactose-6-phosphate as an alternative to disodium phosphate in the production of processed cheese food.

Processed cheese food (PCF) is a dairy product prepared by blending dairy ingredients with nondairy ingredients and heating the blend with agitation to produce a homogeneous product with an extended shelf life. Emulsifying salts (ES), such as disodium phosphate (DSP) and trisodium citrate, have a critical effect on the emulsification characteristics of casein by sequestering the calcium from the calcium-paracaseinate phosphate complex in natural cheese. Lactose-6-phosphate (LP) is an organic compound produced from lactose that has the potential to function as ES. Lactose-6-phosphate is not approved for use as a substitute for ES in the large-scale production of PC. The objective of this study was to produce PCF with LP instead of DSP. Lactose-6-phosphate was prepared by mixing 1 mol of α-lactose with 0.5 mol of sodium cyclo-triphosphate. The pH of recombined solutions was adjusted using sodium hydroxide to get a pH of 12 to obtain 60.74% LP. The solution was stirred for 3 d at room temperature and then concentrated to 52% total solids (TS). The ingredients in the PCF formulations were Cheddar cheese, butter, water, milk permeate powder, and LP (at a ratio of 2.0, 2.4, 2.8, 3.2, 4.0, 5.0, and 6.0%) were formulated to contain 17.0% protein, 25.0% fat, 44.0% moisture, and 2.0% salt. Processed cheese food made with 2.0% DSP was also produced as a control. The PCF was prepared by mixing all ingredients in a Kitchen Aid stand mixer to make a homogeneous paste. A 25-g sample of the mixture was cooked in the rapid visco analyzer (Perten RVA 4500, Macquarie Park, Australia) for 3 min at 95°C at 1,000 rpm for the first 2 min and 160 rpm for the last minute. The PCF was then transferred into molds and refrigerated till further analyses. The PCF was analyzed for moisture, pH, end apparent cooked viscosity, hardness, melted diameter, and melting temperature. The experiment was repeated 3 times using different batches of LP. The moisture of PCF ranged from 42.3% to 44.0% with a pH of 5.6 to 5.8. The end apparent cooked viscosity increased from 818.0 to 2,060.0 cP as the level of LP raised from 0.63% to 1.90%, whereas it was 660.0 cP in control. The hardness of PCF made with LP elevated from 61.9 to 110.1g as the level of LP increased; however, it was 85.6 g in control. The melted diameter decreased from 43 mm in control to 29 mm in 1.90% LP, while the melting temperature of PCF increased from 37.7°C in control to 59.0°C in 1.90% LP. We conclude that LP can be used as a substitute for DSP in PCF manufacture and has more capacity than DSP.