Xu Z Q, He Y Q, Huang J H, Qiu Z W, Zeng X X
Department of Stomatology, Teaching Hospital of Fujian Medical University & Affiliated Hospital of Putian University, Putian 351100, China.
Zhonghua Kou Qiang Yi Xue Za Zhi. 2024 Feb 9;59(2):165-172. doi: 10.3760/cma.j.cn112144-20230926-00170.
To develope a titanium specimen with good osteogenic activity through fabrication of a composite hydroxyapatite coating on ordered micro-/nanotextured titanium surface. An ordered micro-/nanotextured structure was prepared on the surface of titanium (the control), and then hydroxyapatite was deposited on the as-prepared ordered micro-/nanotextured structure by alternative loop immersion method. The ordered micro-/nanotextured structures before and after hydroxyapatite deposition were denoted as HA and MN, respectively. Surface morphology was observed using a scanning electron microscope. Bone marrow mesenchymal stem cells (BMMSC) were seeded on the surface of three different materials. Cell morphology was observed with a scanning electron microscope. Cell adhesion and cell proliferation were evaluated using 4', 6-diamidino-2-phenylindole staining and cell counting kit-8 assay, respectively. Extracellular matrix mineralization and the expression levels of osteogenesis-related genes were evaluated by alizarin red staining and real-time quantitative PCR, respectively. Each group has three samples in every experiment. After alternative loop immersing, the MN's original microholes (20 μm in diameter) were retained, and the uniform petal-like hydroxyapatite was deposited on the MN's original titania nanotubes (70 nm in diameter). Compared with the control, BMMSC on MN and HA elongated further and intersected along the micron structure with noticeable pseudopodia and pseudoplates, and the trend was more pronounced especially on HA. The number of early adherent cells on HA was remarkably larger than that on the control and MN at each time point (0.05). On day 1, the value of cell proliferation on HA was significantly higher than that on the control and MN (0.05). The value of cell proliferation on HA was significantly lower than that on the control and MN on day 3 (<0.05). On day 7, the value of cell proliferation on HA was significantly lower than that on MN (<0.05), but there was no statistically significant difference in the value of cell proliferation between HA and the control on day 7 (>0.05). The value of extracellular matrix mineralization on HA (0.607±0.011) was significantly higher than that on the control and MN (0.268±0.025 and 0.522±0.022, respectively) (=-0.25, <0.001; =-0.34, <0.001). The expression levels of bone related genes on HA were significantly higher than those on the control and MN (<0.05). HA could promote the BMMSC adhesion and osteogenic differentiation, support BMMSC proliferation, and demonstrate good osteogenic activity.
通过在有序的微/纳米纹理钛表面制备复合羟基磷灰石涂层,来开发具有良好成骨活性的钛试样。在钛表面(对照组)制备有序的微/纳米纹理结构,然后通过交替循环浸渍法将羟基磷灰石沉积在制备好的有序微/纳米纹理结构上。羟基磷灰石沉积前后的有序微/纳米纹理结构分别记为HA和MN。使用扫描电子显微镜观察表面形貌。将骨髓间充质干细胞(BMMSC)接种在三种不同材料的表面。用扫描电子显微镜观察细胞形态。分别使用4',6-二脒基-2-苯基吲哚染色和细胞计数试剂盒-8法评估细胞粘附和细胞增殖。分别通过茜素红染色和实时定量PCR评估细胞外基质矿化和成骨相关基因的表达水平。每个实验每组有三个样本。交替循环浸渍后,MN原来的微孔(直径20μm)得以保留,均匀的花瓣状羟基磷灰石沉积在MN原来的二氧化钛纳米管(直径70nm)上。与对照组相比,MN和HA上的BMMSC进一步伸长,并沿着微米结构交叉,有明显的伪足和伪板,尤其是在HA上这种趋势更明显。在每个时间点,HA上早期粘附细胞的数量显著多于对照组和MN(P<0.05)。在第1天,HA上细胞增殖的值显著高于对照组和MN(P<0.05)。在第3天,HA上细胞增殖的值显著低于对照组和MN(P<0.05)。在第7天,HA上细胞增殖的值显著低于MN(P<0.05),但在第7天HA和对照组之间细胞增殖的值没有统计学显著差异(P>0.05)。HA上细胞外基质矿化的值(0.607±0.011)显著高于对照组和MN(分别为0.268±0.025和0.522±0.022)(P=-0.25,P<0.001;P=-0.34,P<0.001)。HA上骨相关基因的表达水平显著高于对照组和MN(P<0.05)。HA可促进BMMSC粘附和成骨分化,支持BMMSC增殖,并表现出良好的成骨活性。