Suppr超能文献

通过臭氧水对选定的致病性和非致病性细菌进行灭活动力学研究,以验证其在纯水中的最小使用量。

Inactivation kinetics of selected pathogenic and non-pathogenic bacteria by aqueous ozone to validate minimum usage in purified water.

作者信息

Lou Yuqian, Kasler David R, Hawkins Zach L, Li Zhen, Sannito Dan, Fritz Ronald D, Yousef Ahmed E

机构信息

PepsiCo R&D, Valhalla, NY, United States.

Department of Food Science and Technology, The Ohio State University, Columbus, OH, United States.

出版信息

Front Microbiol. 2024 Jan 15;14:1258381. doi: 10.3389/fmicb.2023.1258381. eCollection 2023.

Abstract

Ozone is often used as an antimicrobial agent at the final step in purified water processing. When used in purified bottled water manufacturing, residual ozone should not exceed 0.4 mg/L, per US-FDA regulations. These regulations require the control of and other coliform bacteria; however, non-coliform pathogens can contaminate bottled water. Hence, it is prudent to test the efficacy of ozone against such pathogens to determine if the regulated ozone level adequately ensures the safety of the product. Inactivation of selected pathogenic and non-pathogenic bacteria in purified water was investigated as a function of ozone dose, expressed in Ct units (mg O*min/L). Bacterial species tested were , (two serotypes), (three strains), , and (three serovars). Resulting dose (Ct)-response (reduction in populations' log CFU/mL) relationships were mostly linear with obvious heteroscedasticity. This heteroscedastic relationship required developing a novel statistical approach to analyze these data so that the lower bound of the dose-response relationships can be determined and appropriate predictive models for such a bound can be formulated. An example of this analysis was determining the 95%-confidence lower bound equation for the pooled dose-responses of all tested species; the model can be presented as follows: = 3.80 + 1.84. Based on this relationship, application ozone at a Ct of 0.832 and 21°C achieves ≥ 5-log reduction in the population of any of the tested pathogenic and non-pathogenic bacteria. This dose can be implemented by applying ozone at 0.832 mg/L for 1 min, 0.416 mg/L for 2 min, or other combinations. The study also proved the suitability of ATCC 8459 as a surrogate strain for the pathogens tested in the current study for validating water decontamination processes by ozone. In conclusion, the study findings can be usefully implemented in processing validation of purified water and possibly other water types.

摘要

臭氧通常在纯净水生产的最后一步用作抗菌剂。根据美国食品药品监督管理局(US-FDA)的规定,用于生产瓶装纯净水时,残留臭氧含量不得超过0.4毫克/升。这些规定要求对大肠杆菌和其他大肠菌群进行控制;然而,非大肠菌群病原体也可能污染瓶装水。因此,谨慎的做法是测试臭氧对此类病原体的有效性,以确定规定的臭氧水平是否足以确保产品安全。研究了纯净水中选定的致病和非致病细菌的灭活情况与臭氧剂量的关系,臭氧剂量以Ct单位(毫克O·分钟/升)表示。测试的细菌种类有大肠杆菌、金黄色葡萄球菌(两种血清型)、铜绿假单胞菌(三种菌株)、白色念珠菌、粪肠球菌(三种血清型)。由此得出的剂量(Ct)-反应(菌落形成单位/毫升数量减少)关系大多呈线性,但存在明显的异方差性。这种异方差关系需要开发一种新颖的统计方法来分析这些数据,以便确定剂量-反应关系的下限,并为此下限制定合适的预测模型。这种分析的一个例子是确定所有测试菌种合并剂量-反应的95%置信下限方程;该模型可表示如下:y = 3.80 + 1.84x。基于这种关系,在21°C下以0.832的Ct值应用臭氧可使任何测试的致病和非致病细菌数量减少≥5个对数级。该剂量可通过以下方式实现:以0.832毫克/升的浓度应用臭氧1分钟,或以0.416毫克/升的浓度应用臭氧2分钟,或其他组合。该研究还证明了美国典型培养物保藏中心(ATCC)8459作为本研究中测试病原体的替代菌株,适用于通过臭氧验证水净化过程。总之,该研究结果可有效地应用于纯净水以及可能其他类型水的生产验证。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/328e/10829095/d6d1bd28bfaf/fmicb-14-1258381-g001.jpg

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验