Dąbrowska Katarzyna, Palatyńska-Ulatowska Aleksandra, Klimek Leszek
Department of Endodontics, Chair of Conservative Dentistry and Endodontics, Medical University of Lodz, 251 Pomorska Street, 92-217 Lodz, Poland.
Institute of Materials Science and Technology, Technical University of Lodz, 1/15 Stefanowskiego Street, 90-924 Lodz, Poland.
Materials (Basel). 2024 Mar 7;17(6):1230. doi: 10.3390/ma17061230.
The activity of biomaterials used during endodontic treatment can be affected by various factors. One of them is the chemical action of the irrigant that they are exposed to. The aim of this multimethod ex vivo study was to evaluate the influence of ethylenediaminetetraacetic acid (EDTA) on the surface appearance and chemical composition of Biodentine used in perforation repair. Twenty material specimens were prepared according to manufacturers' recommendations and divided into two setting-time-based groups, tested after 45 min (group A) and 24 h (group B) of setting. Material was irrigated with 17% EDTA solution with or without simultaneous ultrasonic activation. The surface characteristics and the chemical composition analysis of the Biodentine specimens were performed with the aid of a scanning electron microscope (SEM) and an energy dispersive spectroscopy (EDS) method, respectively. The volumetric loss of material was measured by dedicated digital software in an optical microscope. Statistical analysis was performed. The EDS study confirmed that after the rinsing protocol, the percentage content of elements differed between the groups. The EDTA rinse, whether ultrasonically activated or not, visibly affected the surface appearance and chemical composition of Biodentine. The specimens' surface subjected to irrigation was more irregular under SEM than in a control group. The US activation of the liquid amplified its impact on the tested material. The average volume loss in group A after 5 min irrigation was 3.98 µm for each µm of the chosen area and it increased up to 7.74 µm/μm after the ultrasonic activation. In group B, indicated volume loss values were 6.30 and 11.70 µm/μm for 5 min irrigation without and with US activation, respectively. Using a 20 min irrigation time and ultrasonic activation increased it up to 32.71 µm/µm. Each rinsing protocol involving irrigation with ethylenediaminetetraacetic acid modified the surface features and the chemical composition of the evaluated hydraulic tricalcium silicate cement. Further research is needed to indicate the possible impact of the observed changes on its long-term clinical performance.
牙髓治疗过程中使用的生物材料的活性会受到多种因素的影响。其中之一是它们所接触的冲洗剂的化学作用。这项多方法体外研究的目的是评估乙二胺四乙酸(EDTA)对用于穿孔修复的生物陶瓷(Biodentine)的表面外观和化学成分的影响。根据制造商的建议制备了20个材料样本,并根据凝固时间分为两组,分别在凝固45分钟后(A组)和24小时后(B组)进行测试。材料用17%的EDTA溶液冲洗,同时进行或不进行超声激活。分别借助扫描电子显微镜(SEM)和能谱(EDS)方法对生物陶瓷样本的表面特征和化学成分进行分析。通过光学显微镜下的专用数字软件测量材料的体积损失。进行了统计分析。EDS研究证实,冲洗方案后,各组元素的百分比含量有所不同。EDTA冲洗,无论是否进行超声激活,都明显影响了生物陶瓷的表面外观和化学成分。在SEM下,接受冲洗的样本表面比对照组更不规则。液体的超声激活增强了其对测试材料的影响。A组在冲洗5分钟后,所选区域每微米的平均体积损失为3.98微米,超声激活后增加到7.74微米/微米。在B组中,5分钟冲洗无超声激活和有超声激活时的指示体积损失值分别为6.30和11.70微米/微米。使用20分钟冲洗时间并进行超声激活,该值增加到32.71微米/微米。每种涉及用乙二胺四乙酸冲洗的方案都改变了所评估的水硬性硅酸三钙水泥的表面特征和化学成分。需要进一步研究以表明观察到的变化对其长期临床性能可能产生的影响。